Xerox DocuPrint 205 Settings Manual

Also see for DocuPrint 205: Operation guide User guide

Xerox DocuPrint 205 Settings Manual Manual pdf 16 page image

16 2 ESC/P Mode SettingsZoom ModeFixed % (default)The scaling factor is automatically calculated from the currently set document size andpaper size, and the document is printed so that the document size print area fits into theprint area of the paper size. For this reason, the scaling factor becomes 100% (actual size)if the paper is the same size as the document. When 2 Up is set, documents are printed sothat the size of two documents fit into the print area of a single page size.Variable %Sets any scaling value. Scaling values in the range 45 to 210% in 1% units can be setindependently for each of the horizontal and vertical directions. Default is 100%.Full SizeThe entire surface area of cut sheet paper is printed in the print area.[Full Size] refers to the scaling factor that is automatically calculated from the currently setdocument size and paper size. The entire surface is printed so that the physical paper sizeof the currently set document size fits into the print area of the paper size.Note• When continuous roll paper is set at [Document Size], the printing result of [Fixed %] or [Full Size] is thesame.• When changing the candidate values by the < > or < > button, the display can be changedcontinuously by holding the button down. The default is displayed by pressing the < > and < >buttons simultaneously.2 Sided PrintSets 2 Sided printing.Candidate values are shown below.[Off] (default)2 sided printing is off.[Long Edge Flip]Printing is done from left to right.[Short Edge Flip]Printing is done from top to bottom.Note• 2 sided printing can be set when the duplex unit (optional) is installed.• [Long Edge Flip] and [Short Edge Flip] cannot be selected when [Output Size] is set to [Postcard].2 Up2 Up is a feature for printing two pages of data on a single page. Documents are printed oneither the left/right side or top/bottom side of the paper depending on the paper direction.Candidate values are as shown below.[Off] (default)2 Up printing is disabled.[Left -> Right]2 Up printing is enabled. The first received page is printed at the left side or top side of thepaper.[Right -> Left]2 Up printing is enabled. The first received page is printed at the right side or bottom sideof the paper.Important• When landscape is specified at [Document Size], the printing result is the same whichever of [Left-> Right] and [Right -> Left] is set.