XEROX WIDE FORMAT COPY SYSTEM Making copies • 51starting position. It then scans the document. The resultingimage is electronically sent to the Printer and your copy isprinted.NOTE: If AUTOSCAN is disabled, you will need to press the Start key tobegin the scan. Refer to "Controlling the scan" on the previous page.NOTE: If the PRODUCTIVITY mode is enabled the document will startscanning immediately. If the PRODUCTIVITY mode is not enabled, thedocument will pre-scan a small distance then reverse itself beforestarting the complete scan.3. When the document is returned to the READY position, do oneof the following:• Pull the document to remove it. Lift the Thick Document Lever toremove fragile or thick documents.• Press the Start key on the Scanner Control Panel to scan thedocument again.NOTE: If DOCUMENT RETURN is set to REAR, the document isdelivered to the rear Stacker. Some documents exit to the rear Stackerregardless of the DOCUMENT RETURN setting. Refer to "Controllingthe scan" on the previous page.Making a copy the same size as theoriginal document1. Set the Media Selection Source to Auto. The Auto indicatorlamp illuminates. This setting allows the WIDE FORMAT COPYSYSTEM to automatically select the available media roll thatbest fits the image width.NOTE: If the correct media size is not loaded, the next larger size will beused.2. Select the Media Selection, Type. The default setting is Bond.3. Set the Media Selection, Output Format to Synchro. Thissetting cuts the media to the same length as the originaldocument.4. Set Reduce/Enlarge to Preset. If the size is not already set to100%, use the Previous and Next keys to select a reduction andpress the Enter key.5. Insert the document face down into the Scanner. If the scandoes not start automatically, press the Start key.NOTE: To set the scan to begin automatically, refer to "Scanner Control"in the "Main Menu" section.NOTE: If the image needs to be rotated to fit on the selected media size,additional processing time is required. If possible, feed the original
