X-Rite i1PRO Quick Start Manual

Also see for i1Pro: User manual

Contents

X-Rite i1PRO Quick Start Manual Manual pdf 2 page image

ENImportant NoticesThis device contains LED's, which are classified as Exempt (no risk) under IEC62471-1:2006 orRisk Group 1 (low risk) under EN62471-1:2008. Hazard group “Blue-Light Small Source” maypose a low risk under EN62471, to minimize risk avoid looking directly at the light.EQUIPMENT INFORMATIONUse of this equipment in a manner other than that specified by X-Rite, Incorporated may compromisedesign integrity and become unsafe.WARNING: This instrument is not for use in explosive environments.ADVERTENCIA – NO use este aparato en los ambientes explosivos.AVVERTIMENTO – NON usare questo apparecchio in ambienti esplosivi.WARNUNG: Das Gerät darf in einer explosiven Umgebung NICHT verwendet werden.AVERTISSEMENT: Cet instrument ne doit pas être utilisé dans un environnement explosif.RoHS/WEEEX-Rite products meet the Restriction of Hazardous Substances (RoHS) Directive 2002/95/EC andEuropean Union – Waste Electrical and Electronic Equipment (WEEE) Directive 2002/96/EC. Please referto www.xrite.com for more information on X-Rite’s compliance with the RoHS/WEEE directives.If this product is used in a manner not specified by the instruction, the safety protection provided by the devicemay be impaired or become inoperable.CE Declaration LED ILLUMINATIONManufacturer’s Name: X-Rite, IncorporatedAuthorized Representative: X-Rite, IncorporatedSiemensstraße 12b • 63263 Neu-Isenburg • GermanyPhone:+49 (0) 61 02-79 57-0 • Fax: +49 (0) 61 02 -79 57-57Model Name: i1ProDirective(s) Conformance: EMC 2004/108/EC LVD 2006/95/ECFEDERAL COMMUNICATIONS COMMISSION NOTICENOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant toPart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed andused in accordance with the instructions, may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference toradio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to tryto correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.INDUSTRY CANADA COMPLIANCE STATEMENTThis Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.NOTE: USB interface cable ( 2.0 m) shipped with this device must be used in order to maintain compliance withthe desired CE mark requirements, FCC Part 15 Rules, and Canadian ICES-003.• Modifications not expressly approved by the manufacturer could void the user's authority to operateThis equipment is intended for use only with UL listed ITE equipment.the equipment under FCC rules.Safety Information