X-Rite i1PRO Quick Start Manual

Also see for i1Pro: User manual

Contents

X-Rite i1PRO Quick Start Manual Manual pdf 13 page image

ENSpot MeasurementTo prepare your i1Pro device for spot measurement you need to mount the i1Pro deviceon the positioning target. Make sure your device is calibrated and the statusindicators are pulsating white before you mount it. Refer to the user guide of yourmeasurement software for further details on the spot measurement process.1. Mount the i1Pro measurement device on the positioning target by inserting themounting connector on the positioning target in the mounting interface at the rear ofthe i1Pro device.2. Configure your software to take spot measurements.3. Position the device on the patch you would like to measure.4. Press the measurement button on the device. Status indicator lights switch offduring a measurement and pulsate green once the measurement has beensuccessfully finished.5. To remove the i1Pro device from the positioning target, gently pull the mountingconnector with the positioning target out of the mounting interface at the rear of thei1Pro device.