Whirlpool GBS277PDB Technical Manual

Also see for GBS277PDB: Use and care guide Installation instructions Dimension Guide

Contents

4-156. To remove the convection fan motor:a) If not already done, remove the con-vection cover and the convection bakeelement from the rear of the oven liner(see page 4-14).b) Use a 10 mm (7/16˝) socket and re-move the hex nut from the convectionfan. NOTE: The nut has a left-rotationthread for removal.10 mm(7/16˝)Hex NutConvectionFand) Pull the oven out of its mounting loca-tion (see page 4-4, steps 1 through 3 forthe procedure) so that you can accessthe rear cover.e) Remove the rear cover from the oven(see page 4-5 for the procedure).c) Remove the three front convection fanmotor screws from the rear of the ovenliner.ConvectionFan MotorFront Screw(1 of 3)f) Remove the two rear convection fanmotor mounting screws from the oven,and remove the motor from the rear ofthe oven.Convection Fan MotorRear Screw (1 of 2)Convection FanMotor TerminalsConvectionFan Motor