WAGNER ProSpray 3.23 Operating Manual

Also see for ProSpray 3.21: Owner's manual Owner's manual Operating manual Operating manual Original operating manual

WAGNER ProSpray 3.23 Operating Manual Manual pdf 28 page image

26 ProSpray 3.23GBDescription of unit Starting operation3.5 Technical dataVoltage: 220-240 Volt , 50/60 HzMax. current consumption: 6.0 APower cord: 3 x 1.5 mm2 – 6 mAcceptance capacity: 1035 WattMax. operating pressure: 221 bar (22.1 MPa)Volume flow at 12 MPa(120 bar) with water: 2.3 l/minMax tip size: 0.024 inch – 0.61 mmMax. temperature of thecoating material: 43°CMax viscosity: 20.000 mPa·sWeight: 17.7 kgSpecial high-pressure hose: DN 6 mm, 15 m, connectionthread M 16 x 1.5Dimensions (L X W X H): 436 x 369 x 416 mmMax sound pressure level: 80 dB (A) ** Place of measuring: 1 m in distance from the unit and 1.6m above the floor, 12 MPa (120 bar) operating pressure,reverberant floor.3.6 Transportation in vehicleSecure the unit with a suitable fastening.4. Starting operation4.1 High-pressure hose, spray gun and separatingoil1. Screw the pressure gauge (1) to the coating material outlet(Fig. 2, Item 2).2. Screw the high-pressure hose (3) to the coating materialoutlet on the pressure gauge (Fig. 2, Item 4).3. Screw the spray gun (5) with the selected tip onto the high-pressure hose.4. Tighten the union nuts at the high-pressure hoses firmly sothat coating material does not leak.514235. Remove the oil cup cap with a straight-slot screwdriver.6. Fill the oil cup with EasyGlide (Fig. 3) until the oil gauge (6) isshowing that it is full.AttentionEasyGlide prevents increased wear and tear to thepackings.7. Replace oil cup cap.8. Press oil button 2-5 times to prime the oiler. Press once forevery eight hours of usage to lubricate the fluid section.9. Fully depress the pusher stem to make sure the inlet ball isfree.