ENGLISH15E6.2 Installation diagramThe following installation diagrams give the machine overall dimensions and position of water and electrical connections.IMPORTANT!Make sure to install an extractor hood to remove the steam produced by the machine.The hood air flow must be calculated taking into account the type of installation and the work environ-ment where it is installed. In any case, an air flow rate of between 590 cfm (1000 m 3 /h) and 885 cfm(1500 m 3 /h) is recommended.LEGENDWI Water inletD Drain outletEI Power supply entryEQ Equipotential screwXD Pipe inlet for detergentXR Pipe inlet for rinse aidXI Pipe inlet for de-lime