VECTRIX VX-2 SERVICE MANUALSECTION B-18:REAR SUSPENSIONPreparations:Disassemble Motor see Section C-16Unscrew 3 inner hex cap bolts and nuts by using anAllen key 4mm and an open wrench 10mmRemove the Plastic cover, rear suspensionRemark:Put up the back of the battery case on a supporterUnscrew the nut #1 by using a open wrench 14mmUnscrew the bolt #2 by using a open wrench 13mm andremove the boltRemark:It is not necessary to remove any covers or battery2 1Unscrew the two nuts and hexagon bolts by using 18mmand 19mm open wrench and remove the rear suspensionRemark:It is not necessary to remove any covers or batteryVersion 1.0/May 2011VECTRIX, LLC