VeEX MTTplus User Manual

Also see for MTTplus: Getting started guide

Contents

VeEX MTTplus User Manual Manual pdf 36 page image

7.0 Tools7.1 IP ToolsThe 10/100BaseT management port is located on the right hand side of the unit. This port can be used to connect to the unit formanagement purposes (results retrieval, software upgrade, remote connectivity ...).You can access the management port configuration on the Tools > IP Tools menu.7.1.1 setupBy detault the IP configuration is set to DHCP and the unit will automatically attempt to connect.For IP configuration, the following fields are required. Additional fields vary depending on Static or DHCP connection.Port: Select Management Port from the drop-down menuProfile: Default, Delete, Save, Save as..., Default, or Last configurationIP Address: Select from Static or DHCPStatic: If Static is selected, the user will manually enter the IP address parameters (local IP, Gateway IP and DNSserver IP)DHCP: If DHCP is selected, the unit will obtain IP address parameters from the DHCP serverGateway and DNS: Enable or DisableEnabled: If enabled, enter the IPv4 address of the Gateway and DNS server in Static mode, or use the IP addressprovided by the DHCP server in DHCP modeDisabled: If disabled, no Gateway or DNS server will be used for the testsEnter all parameters then press Connect to start the test.DHCP SetupFor Static type connection, these additional fields are required:Static: The user is required to enter a Local IP, Gateway address (if Gateway and DNS are set to Enable), and Subnet. All Staticfields can be filled by tapping on the section to access an alphanumeric keypad.Local IP: IPv4 address of the test set.Subnet: Enter the subnet mask.Gateway and DNS: Enable or Disable. If set to enable, Gateway and DNS fields become available.Gateway: Off or On. IPv4 address of the network gateway.DNS: Off, Primary, or Primary & Secondary. If set to Primary or Primary & Secondary, a DNS IP is required in orderto use the URL as a destination.Enter all parameters then press Connect to start the test.MTTplus e_Manual D07-00-096P RevA00Page 36 of 66