V2 CITY1 Manual

Also see for CITY1: Manual

Contents

ENGLISH30CONTROL PANELWhen power is on, the control unit checks that display correctlyoperates by switching on all segments for 1.5 sec. 8.8.8.8.Firmware version, e.g. Pr 2.0, will be viewed in the following 1.5sec. Panel will be viewed upon completion of this test.The control panel represents the physical status of theterminal board contacts and of the program mode keys: if theupper vertical segment is on, the contact is closed; if the lowervertical segment is on, the contact is open (the above pictureshows an instance where the inputs START, START P, FOTO 1,FOTO 2,COSTA 1, COSTA 2 and STOP have all been correctlyconnected).Points being among display digits show the status ofprogramming push-buttons: as soon as a push-button is pressed,its relevant point turns on.The arrows on the display left side show the status of the ends ofstroke. As for a one door-gate, arrows turn on when its end ofstroke shows that the gate is completely closed orcompletely open.As for a two-door gate, arrows turn on when both the ends ofstroke show that both the doors are completely closed orcompletely open; the arrow will blink in case only one doorreaches its end of stroke.WARNING: these functions have not been activated in case ofends of stroke being connected in series to the motor.The arrows on the display right side show the gate status:• The highest arrow turns on when the gate is into its openingphase. If it blinks, it means that the opening has beencaused by a safety device (border or obstacle detector).• The central arrow shows that the gate is on pause. If itblinks, it means that the time countdown for the automaticclosing has been activated.• The lowest arrow blinks when the gate is into its closingphase. If it blinks, it means that the closing has beencaused by a safety device (border or obstacle detector).USE OF DOWN MENU AND UP KEYS FORPROGRAMMINGControl unit time and function programming is made within aspecial configuration menu, to which you can access and whereyou can shift through DOWN, MENU and UP keys placed underthe display.Hold down the MENU key until dEF appears on display, toactivate the programming mode while display views the panel.Configuration menu consists of a list of configurable items; thewording appearing on display will show the current selected item.By pressing DOWN, you will pass to the next item; by pressing UP,you will return to the previous item.By pressing MENU, you can view the current value of selecteditem and possibly change it.The last menu item (FinE) allows storing the carried outchanges and going back to the control unit normal operation.You must exit from programming mode through this menu itemif you do not want to lose your configuration.WARNING: in case no operation is carried out for more than oneminute, the control unit exits from the programming modewithout saving any of your setups and changes, which will getlost.By holding down the DOWN key, configuration menu items willscroll fast, until item FinE is viewed. Viceversa, by holding downthe UP key, items will scroll fast backwards until item dEF isviewed. In this way, you can quickly reach either the top orbottom of the list.There are the following three kinds of menu items:• Function menu• Time menu• Value menuFunction menu setupFunction menus allow selecting a function from among a groupof available options. When you enter into a function menu, thecurrent active option will be viewed; you can scroll all availableoptions through DOWN and UP keys. By pressing the MENU key,you will activate the option viewed and you will return to theconfiguration menu.