|
19new code will be flashed to you and 3 short beeps to indicate correct entry or 1 longbeep if not accepted. Press <PROG> and <ENTER> exit user Code Program mode.Press enter Master code and . The display will show “Client Mode”.How t o Add or Chang e U se r CodeWhile in CLIENT mode, press <PROG> and the User number (2 to 99) to add orchange the code. Use the numeric keyboard to enter the new code. The code can holdany combination of 1 to 6 digits. Press <ENTER> to save your new code.Repeat the procedure for all users or use arrow (MEM) key to advance to next user.Press <PROG> and <ENTER> to exit Local Program mode.How to D elete U se r CodeWhile in CLIENT mode, press <PROG> and the User number (2 to 99) you intend todelete. The display shows the code.Press <CONTROL> and<0> simultaneously to delete User code. Press <ENTER> tosave the change.Press <PROG> and <ENTER> exit Client Program mode.How t o Add or Chang e T el epho ne N umbe r sYour panel will accept up to 6 phone numbers with a total of 16 digits. Your panel can becan be programmed to dial all or any of these depending on the event which hasoccurred.(The six phone numbers are at program address 691 through to 696).While in CLIENT mode, key in the following sequence <691> (The address for telephone number 1), The existing number will be flashed out at theKeypad then enter The new numbers will be flashedback to confirm acceptance.Client ModeUser 3 Code56789User 8 Code8765
|
