|
18Press enter Master code and . The Program indicator lightsup to indicate that the system is in User programming mode.If you get a single long beep at this point and the Program LED doesn’t turn on, it meansyour code cannot access Program mode.How t o exit progr am modeTo exit out of program mode press and .The LCD display shows the system type, date and time.How t o Chang e or Add CodesAbout Master code and User codeThe factory default master code (123) is intended as a preliminary control of the alarmsystem. After FreeWave is installed and put into service, the code can be changed toany code known to the Master user. The Master user can define up to 99 user codes. Tolimit access rights, the holder of the Master code can ask the installer to define severalUser profiles.Access rights are listed below:- User code has Area A and/or B or C or D permission- User code can arm and/or disarm arm an area- User code can arm and/or disarm arm an area in Stay mode- User code can change their code- User code can change user’s code- User code can change dialer telephone numbers- User code can alter the real time clock- User can answer an incoming call and start up/down load- User can allow access to installer program mode from client mode.- Initiate Walk-test mode.How to Chang e Maste r CodeWhile in CLIENT mode, Press <PROGRAM> and 1 to change Master code press, the code digit will be flashed back to you. Use the numeric keyboard to enteryour new Master code. The code can hold any combination of 1 to 6 digits. It isrecommended using a multi-digit code. . Press <ENTER> to save your new code, theUltra - 16TIMEDATE
|
