Menu
Ultra 8/16 Operator's Manual
                           | |
Contents
| 
13How to Ar m P a r titio nsThe protected area can be grouped into 4 separate partitions (A, B, C, D). The systemcan be grouped for User ‘s convenience to separate, in a business environment, theoffices from the warehouse area, or in a private residence, the different rooms of thehome, e.g., living room, bedroom, etc.To arm partition A enter user code for partition ATo arm partition B enter user code for partition BTo arm partition C enter user code for partition CTo arm partition D enter user code for partition DNote: to arming partition with code see page 9 “How to arm the system before exit”During exit delay you can leave premises. At the end of the procedure, the ARMEDindicator lights up to indicate that the system is armed, and the system message isdisplayed(The indicators may go out after a few seconds, depending on the installer's setting).To disarm partition, see "Disarming the System".If enabled by the installer,to arm the partition A, press for 2 seconds.To arm partition B, press for 2 secondsThe same procedure is also applicable to partition B.During exit delay you can leave premises. At the end of the procedure the ARMEDindicator lights up to indicate that the system is armed and system message is displayed.(The indicators may go out after a few seconds, depending on the installer's setting).Areas DisarmedA - - -Areas Exiting- BAreas Armed- BAreas ArmedA - - - |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved