Low power WIFI module user manual http://en.usr.cnJinan USR IOT Technology Limited tec@usr.cnPage 57/72 num：time calibration inverval，range:0~720, default:30 minutes, 10 minutes foreach step, set 0 means no time calibration automatically.4.2.2.61. AT+NTPEN Function: Enable/Disable time calibration function. Format: Query OperationAT+ NTPEN+ok=< LF >< LF > Set OperationAT+ NTPEN=<status>+ok< LF >< LF > Parameters: status：status of time calibration on：Enable time calibration off：Disable time calibration4.2.2.62. AT+NTPTM Function: Query network time Format: Query OperationAT+ NTPTM+ok= LF >< LF > Parameters: time：networ time, for example: 2013-10-9 16:10:42 Wed，if it shows NotAvailable means that the time calibration function is not enabled or the moduledoesn’t connect to the internet.4.2.2.63. AT+WRMID Function: Set module ID; Format: Set OperationAT+ WRMID=<wrmid> < LF >< LF > Parameters: wrmid: set module’s ID (within 20 characters).4.2.2.64. AT+RLDEN Function: Set/Query GPIO45 function status Format: Query OperationAT+RLDEN+ok=< LF >< LF > Set OperationAT+RLDEN=
