US Water Systems FNLT-100-HY Owner's Manual

Contents

US Water Systems FNLT-100-HY Owner's Manual Manual pdf 8 page image

8Visit us online at www.USWaterSystems.com Give us a call at: 1-800-608-8792Softener PreparationFusion NLT Tank Installation InstructionsWATER PRESSURE: A minimum of 20 pounds of water pressure is required for regeneration valveto operate effectively.ELECTRICAL FACILITIES: An uninterrupted alternating current (A/C) supply is required. Note: Othervoltages are available. Please make sure your voltage supply is compatible with your unit before installation.EXISTING PLUMBING: Condition of existing plumbing should be free from lime and iron buildup.Piping that is built up heavily with lime and/or iron should be replaced.LOCATION OF FUSION NLT TANK AND DRAIN: The Infusion tank should be located close to a drainto prevent air breaks and back flow.CAUTION: Water pressure is not to exceed 80 psi, water temperature is not to exceed 110°F (43°C),and the unit cannot be subjected to freezing conditions.Media Installation1) Remove the tank from carton.2) Verify the riser tube is centered in the bottom center of the tank. A flashlight may benecessary.