U-Line 2115R Service Manual

Also see for 2175DWRR: Use and care guide Specifications Supplementary guide Installation guide Use and care guide

Contents

U-Line 2115R Service Manual Manual pdf 69 page image

3-54Section 3 - Service and RepairIce Cube Thickness AdjustmentINTERVAL - AS REQUIREDIce thickness adjustments are made using the control panel as follows:1. To enter the thickness adjustment mode:a. Touch and hold the UP ARROW button.b. Touch and release the DOWN ARROW button three times,then release the UP ARROW button.c. The display will switch to “0” to confirm the thicknessadjustment mode has been selected.2. The factory setting is “0,” and the total range of adjustment is -5 to+5 (ideal range is -1 to +1). Use the UP ARROW button to raisethe setting and thicken the ice bridge, or the DOWN ARROWbutton to lower the setting to thin the ice bridge.IMPORTANTIMPORTANTIce thickness adjustment should only be made oneincrement at a time. Allow ice maker production to stabilizefor 24 hours before rechecking ice thickness.3. Touch and release the LIGHT button key to exit the ice thicknessadjustment mode.4. Remove all ice from the storage bin.Figure 56Ice cubes in any given batch will vary, so it is necessary to choosecubes from the sample area for comparison when makingadjustments. If further adjustments are desired, repeat Steps 1through 4.The ice cube thickness is factory set for best overall performance.The factory setting is designed to maintain an ice bridge ofapproximately 1/16" to 1/8" under normal conditions resulting in adimple of approximately 1/4" to 1/2" in depth. A fuller cube with lessof a dimple results in a thicker ice bridge. As the ice bridge becomesthicker, the tendency for the cubes to stay together as a slabincreases. A bridge thicker than 1/8" may cause cubes to overfill theice bucket.Figure 57SampleareaULIN_0063_AGOODBRIDGETOO THINBRIDGETOO THICKDIMPLETOO DEEPLITTLE ORNO DIMPLE1/4" TO 1/2"DIMPLE1/16" TO 1/8"ICE BRIDGEBADULIN_0300_ACube Types