6. If necessary, press [Original Feed Type] to specify settings such as original orientation.For details, see "Setting of Original Feed Type".7. Specify the destination.For details, see "Specifying the Destination Client Computer".8. Press the [Start] key.When scanning batches, place subsequent originals after the scan files have been sent.• If you are using this machine as a WSD scanner, you can specify only one destination per scanjob.• You cannot preview scanned images. After pressing the [Start] key, you can view the scannedimages on your computer.• To cancel a specified destination, press the destination again, or press the [Clear] key.• To cancel scanning, press the [Stop] key.• You cannot store files scanned using WSD on the machine.• You cannot use WSD to send files stored on the machine.• You cannot scan originals while other originals are being scanned.• Two-sided originals are scanned for sideways opening (top-to-top orientation).• If scanning takes too long, the client computer might time out, causing the message "AutomaticScanning could not be completed" to appear. If this happens, the scan files are sent again.Depending on the settings of the client computer, you might have to perform a procedure on theclient computer directly. To check the files have been sent successfully, use the machine's ScannedFiles Status screen or the client computer. For details, see "Scanned Files Status".• If scanning does not begin after you press the [Start] key, the machine might not be registeredto the computer or the profile might be incorrectly configured. For details, see "Registering themachine to a client computer" or "Creating a New Scan Profile".• After scan files are sent, their destination settings are automatically cleared. If you want topreserve this information, contact your local dealer for details.• p.83 "Switching to the WSD Scanner Screen"• p.88 "Changing a Scan Profile"• p.129 "Adjusting Image Density"• p.130 "Setting of Original Feed Type"• p.84 "Specifying the Destination Client Computer"• p.16 "Scanned Files Status"• p.78 "Registering the machine to a client computer"Basic Procedure for Sending Scan Files Using WSD813
