Toshiba GR-200 Series Instruction Manual

Also see for GR 200 Series: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

6F2T0200 (0.15)GRE200 (1,2)- 438 -Select conditionDPOS01 function (Function ID: 512001)User configurable condition (PLC#2 connection point)Appearance of thecontrols in the samedirectionOFF[SCDEN]*7Fixedlogic[DPOS01-LGSLFFCT]To select logicFrom Control hierarchy *8 (PLC#3 connection point)From CMNCTRL[DPOS01-CTREN]OnAdditional condition (PLC#1 connection point)Double Command Blocking detected*1Other devices traveling detected*2DCB RCV ORTraveling ORDPOS01IN_TMP_32512001 810301EE62DPOS01IN_TMP_31512001 800301EE61DPOS01IN_TMP_28512001 820301ED50SERI_ERRCommand “ON control” receivedCommand “OFF control” receivedreceivedDPOS01_3PH_STATE&&& &&&1≥ 1≥Unmatched condition detected *4Event suppression detected *5= DPOS01_F_QLT_SPPBI board connection error detected*6= DPOS01_F_BI_ERR(512001 8103011F5F)(512001 8203011F60)(512001 3103011001)Serious error detectionFrom TRC*3GEN. TRIPGeneral tripFigure 4.1-13 Select condition logic for ‘ON/OFF’ in DPOS01*91Note: “Double Command Blocking” (DCB) is an operation philosophy in the commoncontrol function (CMNCTRL). It can be used to protect the substation. The usercan program it using GR-TIEMS. The DCB operating signal is denoted as “DCBRCV OR” in Table 4.1-5. For more information, see ChapterControl andmonitoring application:Common controls (→p. 414).2Note: If the event “device-travelling” is detected in the CMNCTRL function, it indicatesthat another operator is changing the status of a device. Thus, the IED shouldinhibit the operation of any device for the duration that the event is detected. Thedetected signal is denoted as “Travelling OR” in Table 4.1-5.3Note: If the issue of a trip command is executed by the IED, any control operation isblocked until the trip operation is completed. When the IED has trip circuitfunction, the trip command is issued at PLC monitoring point “GEN.TRIP” (seeTable 4.1-5, and p. 266).4Note: Criteria “unmatched conditions” are decided when “Test-bit status” in a commandis not identical to “IED test status”.5Note: The function “Event suppression” can detect chattering on BI circuits. (SeeChapter 4.1.6(i)-3)6Note: A supervision of the Binary IO module can detect connection errors for BI circuits.7Note: The Common control (CMNCTRL) function can test and check the ‘On and Off