Toro 25500 Operator's Manual

Also see for RT1200: Installation instructions Operator's manual Operator's manual Guide Operator's manual

Figure 55Rear axle1. Grease fitting (upper pivot) 2. Grease fitting (lower pivot)3. Connect the grease gun to the grease fittings for theforward- and rear-axle tilt pivots; apply 2 or 3 pumpsof grease to each fitting (Figure 56).Figure 561. Grease fittings (4)4. Wipe up any excess grease.Greasing the Front and Rear DriveShaftsService Interval: Every 500 hours1. Clean the grease fittings with a rag.2. Connect the grease gun to the grease fitting for theslide coupling at the forward end of the drive shaft, andapply 2 or 3 pumps of grease to the fitting (Figure 57).Figure 571. Grease fitting (backuniversal joint)2. Grease fitting (forwarduniversal joint)3. Connect the grease gun to the grease fitting for theuniversal joint at the forward end of the drive shaft, andapply 2 or 3 pumps of grease to the fitting (Figure 57).4. Connect the grease gun to the grease fitting for theuniversal joint at the back end of the drive shaft, andapply 2 or 3 pumps of grease to the fitting (Figure 57).5. Wipe up any excess grease.43