Toro 25450A Operator's Manual

Also see for RT1200: Installation instructions Operator's manual Operator's manual Operator's manual Guide

Seat-Height and Seat-Slide ButtonsFigure 171. Seat-slide buttons 5. Seat-frame slide bar2. Seat-height buttons 6. Weight compensator3. Seat-slide lever 7. Armrest-height control4. Seat-rotation lever 8. Lumbar knob (located onthe seat back)• Seat-height buttons–use them to adjust the seat pad upor down (Figure 17).• Seat-slide buttons—use them to slide the seat padforward or rearward (Figure 17).Seat-Frame-Slide Lever and Seat-Base-Slide Lever• Seat-frame-slide lever—Use this lever to adjust theentire seat and frame forward or rearward (Figure 17).• Seat-base-slide lever—Use this lever to move the seatbase forward or rearward on the seat frame (Figure 17).Seat-Rotation Lever and Seat-Weight Compensator• Seat-rotation lever—Use this lever to unlock the seatso that you can rotate the seat to the desired position.The seat will rotate 360° and lock into position at 10°increments (Figure 17).Note: Rotate the seat to the Front position beforedriving the machine.• Seat-weight compensator—Rotate this lever for theweight compensator to adjust the seat support tension forthe weight of the operator (Figure 17).– Rotate the lever for the weight compensator clockwiseto increase the support tension of the seat.– Rotate the lever for the weight compensatorcounterclockwise to reduce the support tension ofthe seat.Armrest-Height ControlRotate the armrest-height control to raise or lower thearmrest (Figure 17).Seat-Lumbar KnobRotate the seat-lumbar knob, found behind the seat, to adjustthe back lumbar support for best comfort (Figure 17).Seat BeltWARNINGOperating the machine without the rolloverprotection system (ROPS) securely in place canresult in serious injury or death if the machine rollsover.• Ensure that the roll bar is securely in place.• Always wear a seat belt with the ROPS in place.• Ensure that the operator seat is properly securedto the machine.Note: Regulations in some localities require that seat belts onconstruction machines be 76 mm (3 inch) wide. Check withlocal authorities regarding the requirements for seat belts.• To fasten the seat belt, insert the tab end into the leftbuckle.Note: Ensure that the tab end and the buckle aresecurely fastened.• To release the seat belt, push the button on the buckle.Battery-Disconnect SwitchThe battery-disconnect switch is located behind the rightengine cowl (Figure 18); use it to electrically disconnect thebattery from the machine.21