50 Adjustment MenuChapter 3 MenuColor Temp Adj Restore Factory Data Resets the color temperature to the default setting.You cannot select this when the setting is the default value.The following message appears to confirm the data reset operation.Restore factory data?OK: To reset the data, press the ENTER (Ent) button.Cancel: To cancel, press the MENU button.Position Adj Adjusts the position of the picture when the analog signal is input.When the item is selected, the signal system to be set is displayed.You can select the item when the composite or Y/C signal from the BKM-227W, or the analogcomponent or analog component RGB signal from the BKM-229X is displayed.To hide the characters on the monitor during adjustmentSet the CHAR OFF button of the controller to on. As the characters on the display arehidden, it becomes easy to adjust the picture. To display the characters, set the CHAR OFFbutton to off.NoteThis menu is not selectable when the internal signal or captured frame is displayed.H Shift Adjusts the horizontal position of the picture.As the setting increases, the picture moves to the right, and as the setting decreases, thepicture moves to the left. [000]Set in the H Shift Offset menu (page 55) of the Input Configuration menu when the differenceof the horizontal position is necessary to adjust for different input signals of the same signalsystem, etc.V Shift Adjusts the vertical position of the picture.As the setting increases, the picture moves up, and as the setting decreases, the picturemoves down. [000]Menu Function and operation ([ ]: factory setting)
