Sony Trimaster PVM-L2300 Operation Manual

Also see for PVM-L2300: Product guide Operation manual Operation manual Manual Operation manual

Contents

12 FeaturesChapter 1 OverviewFor the operation, see “Displaying the Area Marker orAspect Marker” on page 90.Scan selection/Native scan display functionYou can select from under scan (–3%), normal scan (0%)and over scan (mask of the 5% over scan portion in thenormal scan) for the picture display.The monitor is equipped with a native scan displayfunction which maps the pixel of the signal to the panel inone-to-one mode. You can select the mode from ×1, ×2 orAspect Correction to display a signal in native mode. AnSD signal of non-square pixels (the number of H pixels ofthe signal system is 720 or 1440) or a 640 × 480 SD signalof DVI video/HDMI video is displayed correctly byscaling processing of doubling for the V direction andcorrect aspect ratio for the H direction, and the picture isalso optimized and displayed by modifying the aperturecoefficient value, filter coefficient value, etc. in AspectCorrection mode.For the operation, see “Selecting the Native Scan/ScanMode” on page 85.Black detail mode display functionYou can reduce to dull black color by backlight leaking andprecisely assess any parts with low color gradation.You can decrease the black level up to 40% of the normaldisplay (100 cd/m 2 at 100% signal). The parts with highcolor gradation (higher than 75 IRE) are clipped by thedynamic range of the circuit, but a zebra pattern(selectable) is displayed in the clipped portions.For the operation, see “Displaying the Picture in BlackDetail Mode” on page 88.Aspect selectable functionA squeezed and recorded signal is displayed with thecorrect angle. You can select from 4:3 and 16:9 aspectmodes.Remote control function (Ethernet control)The controller controls up to 32 monitors by the Ethernet(10BASE-T/100BASE-TX) connection. Up to fourcontrollers are connected to one monitor in single mode.You can control individual monitors or monitor groupssimply by entering the monitor ID number or group IDnumber. You can also execute the same operation on allconnected monitors, or put all connected monitors into thesame setup and adjustment state.Closed caption display functionEIA/CEA-608 or EIA/CEA-708 standard closed captionsignals superimposed on the SDI signals are displayed byinstalling the optional input adaptor (BKM-244CC).Audio level meter/time code display functionAudio level of the embedded audio and time code signalssuperimposed on the SDI signals are displayed byinstalling the optional input adaptor (BKM-250TG).3D signal analyzing functionLeft (L) and right (R) 3D video signals can be displayed ina checkerboard pattern on the same screen, or they can beswitched alternately by installing the optional inputadaptor (BKM-250TG with serial number 7100001 orhigher). For this function, two-dimensional (2D) view isused. The signals are not displayed in stereoscopic view.For the operation, see “Switching the Display of the 3DVideo Signal” on page 92.Variable picture adjustment functionsAuto chroma, phase and matrix adjustment function areequipped. The white balance is automatically adjusted byusing a commercially available probe (Konica MinoltaCA-210, DK-Technologies PM5639/06, X-Rite Eye-OnePro).Other features• The color temperature is selectable from D65, D93 andUser.• Built-in test pattern for 100% white signal, 20% graysignal, 0% black signal, PLUGE (Picture Line UpGeneration Equipment) signal, color-bar signal, 5 stepgray scale signal and ramp signal.• Chroma Up function that increases the chroma setting by12 dB.• Blue only function and RGB cut off function to monitorsignal noise.• A parallel remote of the contact point control connectoris equipped.