Sony FDA-EV1S Operating Instructions Manual

Also see for FDA-EV1S: Specifications

/Operating Instructions/Mode d’emploi/Manual de instrucciones/© 2011 Sony Corporation Printed in Japan4-295-955-01(1)FDA-EV1S123456712ˎˎˎFDA-EV1S212 FINDER/LCD34567OFFˎˎ122 LOCKONˎˎˎˎFINDER/LCDˎFINDER/LCDˎˎ2ˎˎˎˎˎˎˎ99.99%ˎˎˎˎˎˎˎˎ26.2 mm 34.5 mm 40.4 mm26 gEL1.3 cm 0.52 359 2961001.09 50mm-1m-123 mm21 mm -1m-1-4.0 m-1 +1.0 m-11 11 1ˎˎ1ˎFDA-EV1SˎˎˎFor the customers in the U.S.A.This device complies with Part 15 of the FCC Rules. Operationis subject to the following two conditions:(1) This device may not cause harmful interference, and (2)this device must accept any interference received, includinginterference that may cause undesired operation.CAUTIONYou are cautioned that any changes or modifications notexpressly approved in this manual could void your authorityto operate this equipment.NOTE:This equipment has been tested and found to comply withthe limits for a Class B digital device, pursuant to Part 15of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in aresidential installation. This equipment generates, uses, andcan radiate radio frequency energy and, if not installed andused in accordance with the instructions, may cause harmfulinterference to radio communications.However, there is no guarantee that interference will notoccur in a particular installation. If this equipment does causeharmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, theuser is encouraged to try to correct the interference by one ormore of the following measures:Reorient or relocate the receiving antenna.ˋˋIncrease the separation between the equipment andˋˋreceiver.Connect the equipment into an outlet on a circuit differentˋˋfrom that to which the receiver is connected.Consult the dealer or an experienced radio/TV technicianˋˋfor help.For the customers in CanadaThis Class B digital apparatus complies with Canadian ICES-003.The FDA-EV1S (referred to below as “this unit”) can onlybe used with a Sony Interchangeable Lens Digital Camera(referred to below as “camera”) with a Smart AccessoryTerminal 2. This unit does not support Smart AccessoryTerminal.These cameras are not available in all countries/regions.WARNINGKeep out of reach of small children to prevent accidentalswallowing.To reduce fire or shock hazard, do not expose the unit to rainor moisture.CAUTIONTo avoid injury, be careful not to drop this unit.Careless handling can lead to injury. Identifying the Parts1 Eyepiece sensors2 FINDER/LCD button3 Lock screw4 Eyepiece lens5 Eyepiece cup6 Diopter-adjustment lever7 Connector protect cap Attaching this UnitBefore attaching this unitSet the power of the camera to OFF.ˎRemove the connector protect cap from this unit.ˎTo attach this unit1 Turn off the power of the camera. Align theconnector of this unit with the Smart AccessoryTerminal 2 on the camera and attach this unit.2 Rotate the lock screw of this unit to the LOCKdirection.To detach this unitTurn off the power of the camera and then detach thisunit by following the attaching procedure in reverse.To remove the eyepiece cup, pinch in both sides and pullit firmly. (See illustration )To attach the eyepiece cup, press it until it clicks.Using this unitSet the power of the camera to ON.ˎLook into this unit and adjust the diopter-adjustment leverˎtill the display appears clearly in this unit.When you look into this unit, the image is displayed in thisˎunit due to the action of the eyepiece sensors. When youmove your face from this unit, the image display returns tothe LCD monitor of the camera.Press the FINDER/LCD button of this unit to switch theˎdisplay between this unit and the LCD monitor on thecamera.Depending on the status of use, the eyepiece sensors may beˎactivated so no images appear on the LCD monitor of thecamera. If this happens, press the FINDER/LCD button ofthis unit.Notes on UseDo not touch the eyepiece lens or connector of this unit.ˎYou cannot use this unit together with an external flash orˎother device attached to the camera by the Smart AccessoryTerminal 2.Be careful not to subject this unit to mechanical shockˎwhile attaching it.Do not hold the camera only by this unit.ˎWhen carrying this unit, remove it from the cameraˎfirst. Attach the connector protect cap to this unit.Then put it in the supplied carrying pouch.If you wear glasses and have difficulty in viewing in thisˎunit, you can remove the eyepiece cup from this unit.The display on the LCD monitor of the camera may differˎfrom the display in this unit because of the difference oftheir display sizes.For details about the screen indicator of this unit and howˎto set it with a camera, refer to the Instruction Manual ofyour camera.You can change the angle of this unit depending on theˎsituation of use.The LCD monitor and electronic viewfinder areˎmanufactured using extremely high-precision technologyso over 99.99% of the pixels are operational for effective use.However, there may be some tiny black points and/or brightpoints (white, red, blue or green in color) that constantlyappear on the LCD monitor and electronic viewfinder.These points are normal in the manufacturing process anddo not affect the images in any way.Do not keep the eyepiece lens pointed toward the sun orˎother bright light source.This unit may become warm after extended use. This is notˎa malfunction.Depending on the surrounding lighting conditions or scene,ˎthe movement of the subject may be jerky, or flickering ormoiré patterns may appear in this unit. These do not affectthe recorded image in any way.Do not disassemble this unit or its performanceˎcannot be guaranteed.When using this unit outside, be careful not to get it wetˎwith rain or seawater.Cleaning this unitWipe off any dust from the surface of this unit lightly with aˎsoft clean cloth.Brush off any dust from the eyepiece lens with a blowerˎbrush and wipe it lightly with a soft clean cloth. (Use of acleaning cloth is recommended.)/Electronic Viewfinder/Viseur électronique/SpecificationsDimensions (Approx.)(w/h/d)26.2 mm × 34.5 mm × 40.4 mm(1 1/16 in. × 1 3/8 in. × 1 5/8 in.)Mass Approx. 26 g (0.9 oz.)(excluding the eyepiece cup andprojecting parts)Type Electronic viewfinder(Organic Electro-Luminescence)Screen size 1.3 cm (0.5 type)Total number of dots 2 359 296 dotsFrame coverage Approx. 100%Magnification 1.09 × with 50 mm lens at infinity,–1 m–1 (diopter)Eye Point Approximately 23 mm from theeyepiece, 21 mm from the eyepieceframe at –1 m–1Dioptor Adjustment –4.0 m–1 to +1.0 m–1 (diopter)Included itemsElectronic viewfinder (1), Eyepiece cup (1), Connector protectcap (1), Carrying pouch (1), Set of printed documentationDesign and specifications are subject to change without notice.is a trademark of Sony Corporation.À l’intention des clients aux É.-U.Cet appareil est conforme à la Partie 15 de la réglementationde la FCC des États-Unis. Son utilisation est sujette aux deuxconditions suivantes :(1) Cet appareil ne doit pas générer d’interférences nuisibles et(2) il doit être en mesure d’accepter toute interférence reçue, ycompris les interférences pouvant générer un fonctionnementindésirable.AVERTISSEMENTPar la présente, vous êtes avisé du fait que tout changementou toute modification ne faisant pas l’objet d’une autorisationexpresse dans le présent manuel pourrait annuler votre droitd’utiliser l’appareil.REMARQUE:L’appareil a été testé et est conforme aux exigences d’unappareil numérique de Classe B, conformément à la Partie 15de la réglementation de la FCC.Ces critères sont conçus pour fournir une protectionraisonnable contre les interférences nuisibles dans unenvironnement résidentiel. L’appareil génère, utilise et peutémettre des fréquences radio; s’il n’est pas installé et utiliséconformément aux instructions, il pourrait provoquer desinterférences nuisibles aux communications radio.Cependant, il n’est pas possible de garantir que desinterférences ne seront pas provoquées dans certainesconditions particulières. Si l’appareil devait provoquer desinterférences nuisibles à la réception radio ou à la télévision,ce qui peut être démontré en allumant et éteignant l’appareil,il est recommandé à l’utilisateur d’essayer de corriger cettesituation par l’une ou l’autre des mesures suivantes :Réorienter ou déplacer l’antenne réceptrice.ˋˋAugmenter la distance entre l’appareil et le récepteur.ˋˋBrancher l’appareil dans une prise ou sur un circuit différentˋˋde celui sur lequel le récepteur est branché.Consulter le détaillant ou un technicien expérimenté enˋˋradio/téléviseurs.Pour les clients au CanadaCet appareil numérique de la classe B est conforme à la normeNMB-003 du Canada.Le FDA-EV1S (appelé ci-dessous « cet article ») ne peut êtreutilisé qu’avec un appareil photo à objectif interchangeableSony (appelé ci-dessous « l’appareil photo ») à connectiquepour accessoires 2. Ce n’est pas possible avec la connectiquepour accessoires.Ces appareils photo ne sont pas commercialisés dans tous lespays/régions.AVERTISSEMENTPour éviter toute ingestion accidentelle, rangez cet article horsde portée des enfants.Afin de réduire les risques d’incendie ou de déchargeélectrique, n’exposez pas cet appareil à la pluie ou à l’humidité.ATTENTIONPour éviter toute blessure, faites attention de ne pas laissertomber cet article.Un mauvais maniement peut entraîner des blessures. Identification des éléments1 Capteurs d’oculaire2 Touche FINDER/LCD3 Vis de verrouillage4 Lentille d’oculaire5 Oculaire de visée6 Levier de réglage dioptrique7 Capuchon de protection de connecteur Fixation de cet articleAvant de fixer cet articleMettez l’appareil photo en position OFF.ˎRetirez le capuchon de protection de connecteur de cetˎarticle.Pour rattacher cet article1 Éteignez l’appareil photo. Alignez le connecteur decet article sur la connectique pour accessoires 2 del’appareil photo et rattachez cet article.2 Tournez la vis de verrouillage de cet article dans lesens de LOCK.Pour détacher cet articleÉteignez l’appareil photo et détachez cet article enprocédant à l’inverse de la fixation.(Suite à la page arrière)

/ 2

Related manuals for Sony FDA-EV1S