Sony Digital HDVS HDC-900 Maintenance Manual

Also see for HDC-900/L: Installation and maintenance manual Operation manual Maintenance manual

6-15 (E)HDC-900/950 MMLine selectABA6-5-6. Detail Clip AdjustmentEquipment: Waveform monitor (R, G, B)Test Point: HD SERIAL DIGITAL OUT connectorObject: Grayscale chartPreparations. Menu setting:MENU: PAINTPAGE: KNEEITEM: KNEE → OFFPAGE: DETAIL 1ITEM: DETAIL → ON. Shoot the grayscale chart so that the chart frame isaligned with the underscanned monitor frame.. Iris of the lens: A = 600 ± 20 mVAdjustment Procedures1. Adjust the white balance.AUTO W/B BAL switch (front panel) → WHT2. Make a lines selection at the center white portion ofthe grayscale chart.6-5-5. Level Dependent AdjustmentEquipment: Waveform monitor (R, G, B)Test Point: HD SERIAL DIGITAL OUT connectorObject: Grayscale chartPreparations. Menu setting:MENU: PAINTPAGE: DETAIL 1ITEM: DETAIL → ONITEM: LVL DEP → ON[Reference][Reference][Reference][Reference][Reference]There are two LVL DEP items on the DETAIL 1 page.. Shoot the grayscale chart so that the chart frame isaligned with the underscanned monitor frame.. Iris of the lens: A = 600 ± 20 mVAdjustment ProcedureAdjustment item:MENU: PAINTPAGE: DETAIL 1ITEM: LVL DEPSpecification: Set Level Dep to _99 once. And turnslowly for increment until spikes atportions B just decreased.NoteAfter adjustment is complete, be sure to perform Section 6-5-2 “H/V Ratio Adjustment”.6-5. Video System Level Adjustment (When using the Setup Menu)