277Customising Your Camcorder / Выполнение индивидуальных установок на видеокамереChanging the default settings with the menuIcon/itemTAPE SETREC MODEAUDIO MODEqREMAINMIC LEVELModez SPLPz 12BIT16BITz AUTOONz AUTOMANUALMeaningTo record in the SP (Standard Play) modeTo increase the recording time to 1.5 times the SPmodeTo record in the 12-bit mode (two stereo sounds)To record in the 16-bit mode (one stereo sound withhigh quality)To display the remaining tape bar:• For about eight seconds after a cassette is insertedand your camcorder calculates the remainingamount of tape• For about eight seconds after N or DISPLAY/TOUCH PANEL is pressedTo always display the remaining tape indicatorAdjusts audio recording level automaticallyAdjusts audio recording level manuallyPOWERswitchVCRCAMERAVCRCAMERAVCRCAMERAVCRCAMERANotes on the LP mode•When you record a tape in the LP mode on your camcorder, we recommend playing the tape on yourcamcorder. When you play back the tape on other camcorders or VCRs, noise may occur in picturesor sound.•When you record in the LP mode, we recommend using a Sony Excellence/Master cassette so thatyou can get the most out of your camcorder.•You cannot dub audio on a tape recorded in the LP mode. Use the SP mode for the tape to be audiodubbed.•When you record in the SP and LP modes on one tape or you record some scenes in the LP mode, theplayback picture may be distorted or the time code may not be written properly between scenes.Notes on AUDIO MODE•You cannot dub audio on a tape recorded in the 16-bit mode.•When playing back a tape recorded in the 16-bit mode, you cannot adjust the balance in AUDIO MIX.(continued on the following page)Downloaded From VideoCamera-Manual.com Manuals
