Sony CYBER-SHOT DSC-W40 User Manual

Also see for Cyber-shot DSC-W30: Supplementary guide Brochure Operating instructions Especificacoes User guide

2-673-368-12 (1)© 2006 Sony Corporation Printed in JapanPrinted on 100% recycled paper using VOC(Volatile Organic Compound)-free vegetableoil based ink.continued on the reversePrepare the battery pack• Connect the battery charger to an easily accessible wall outlet (wall socket) close by.• Even if the CHARGE lamp is not lit, the battery charger is not disconnected from the AC power source(mains) as long as it is connected to the wall outlet (wall socket). If some trouble occurs while using thebattery charger, immediately shut off the power by disconnecting the plug from the wall outlet (wall socket).• When charging is finished, disconnect the battery charger from the wall outlet (wall socket), and remove thebattery pack from the battery charger.• The time required to fully charge the battery pack (supplied) from when it is completely discharged at atemperature of 25°C (77°F) is approximately 330 min., and the practical charging time is approximately270 min. Charging may take longer under certain circumstances or conditions.11Battery charger2 Lift out the inlet plug andconnect to the wall outlet(wall socket).1 Insert the battery pack.Push the back part of the battery packgently until it clicks into place.CHARGE lampLight on: ChargingLight off: Completed (Practical charge)If you continue charging the battery pack for aboutone more hour (until it is fully charged), thecharge will last slightly longer.Plug3 Insert the charged battery pack.Open the battery/“Memory Stick Duo”cover.Insert the battery pack whilepressing the battery eject leverwith the tip of the battery.Close the battery/“Memory Stick Duo”cover.Battery eject leverUsing the AC AdaptorYou can connect the camera to a wall outlet (wall socket) using the AC-LS5K AC Adaptor (notsupplied). t “User’s Guide/Troubleshooting” (page 18).To check the remaining battery timePress POWER button to turn on and check the remaining battery on the LCD screen.• It takes about one minute until the correct battery remaining indicator appears.• The displayed battery remaining indicator may not be correct under certain circumstances.To remove the battery packSlide the battery eject lever to pull the battery pack out. Be sure not to drop the battery packwhen pulling it out.To use your camera abroad — Power sourcesYou can use your camera, the battery charger, and the AC-LS5K AC Adaptor (not supplied) inany country or region where the power supply is within 100 V to 240 V AC, 50/60 Hz.• Do not use an electronic transformer (travel converter), as this may cause amalfunction.BatteryremainingindicatorBatteryremainingguidelinesSufficientpowerremainingBattery half full Battery low,recording/playback willstop soon.Change the battery withfully charged one, or chargethe battery. (The warningindicator flashes.)Battery eject leverTurn the camera on/set the clock221 Select . 2 Press the POWER button.Lighting3 Set the clock with the controlbutton.1 Select the date display format with v/V, then pressz.2 Select each item with b/B and set the numeric valuewith v/V, then press z.3 Select [OK] with B, then press z.• To cancel, select [Cancel] and press z.2006 / :/1 1 12 00AMOKCancelClock SetD/M/YM/D/YY/M/D2006 / :/1 1 12 00AMOKCancelClock SetD/M/YM/D/YY/M/D2006 / :/1 1 10 30AMOKCancelClock SetD/M/YM/D/YY/M/DTo change the date and timeSelect [Clock Set] in the (Setup) screen and perform the procedure in step 3 above.t “User’s Guide/Troubleshooting” (pages 46 and 55)On the clock display• Midnight is indicated as 12:00 AM, and noon as 12:00 PM.• If you selected [D/M/Y] in step 3-1, set the time on a 24-hour cycle.When turning on the power• Unless you set the clock, the Clock Set screen appears each time the camera is turned on.• Do not touch the lens portion as the cover opens and the lens portion extends. Also, do not leave the camerawith the lens portion extended for a long period of time with the power off as this may cause malfunction.• The following screen appears when the camera is turned on for the second time or afterwards.To turn off the powerPress the POWER button again.• If the camera is running on battery power and you do not operate the camera for about three minutes, thecamera turns off automatically to prevent wearing down the battery pack (Auto power-off function).Changing the language settingYou can change the screen display to show messages in a specified language. To change thelanguage setting, press MENU to display the menu screen. Select (Setup) with the controlbutton, then, select [ Language] in (Setup1), and select the desired language. t “User’sGuide/Troubleshooting” (page 53)A 1Insert a “Memory Stick Duo” (notsupplied)Select the image size for useWhen there is no “Memory Stick Duo” insertedThe camera records/plays back images using the internal memory. t “User’s Guide/Troubleshooting” (page 26)33Insert the “Memory Stick Duo”all the way in until it clicks.Terminal sideLabeled side44button1 Select a mode.Select .Select .Still image:Movie:2 Press (Image Size).3 Select the size with v / V.• The screen above is for still images.• For movies, select [640(Fine)] (“Memory Stick PRODuo” only), [640(Standard)] or [160].4 Press (Image Size) tocomplete the setting.Image SizeUp to 10x15cm/4x6"printAppx. Image Capacity 33picsOn still image sizesFor details on the image size t “User’s Guide/Troubleshooting” (page 15)1) Images are recorded in the same 3:2 aspect ratio as photograph printing paper or postcards, etc.2) Both edges of the image may be cut off when printing t “User’s Guide/Troubleshooting” (page 89)3) By using a Memory Stick slot or USB connection, you can enjoy higher quality images.On the recordable number of still images and recordable time of moviesRecordable number of still images and recordable time of movies vary depending on the imagesize selected.For details on recordable number or time t “User’s Guide/Troubleshooting” (page 24)• The number of recordable images and time can differ according to shooting conditions.To remove a “Memory Stick Duo”Image size Guidelines No. of images Printing7M (DSC-W70 the defaultsetting)Up to A3/11×17"printLessMoreFineRough6M (DSC-W30/W40/W50 thedefault setting)Up to A4/8×10"print3:2 1) Match 3:2 Aspect Ratio5M (DSC-W70) Up to A4/8×10"print3M Up to 13×18cm/5×7"print2M Up to 10×15cm/4×6"printVGA For E-mail16:9 2) Display On 16:9 HDTV 3)Still images MoviesAccess lamp Open the battery/“Memory Stick Duo” cover, then push the“Memory Stick Duo” in once.When the access lamp is litNever remove the battery/“Memory Stick Duo” or turn offthe power. The data may be corrupted.Maximum numberof recordableimagesMaximumrecordable timeDigital Still CameraRead This FirstDSC-W30/W40/W50/W70Operating InstructionsBefore operating the unit, please read this manual and “User’s Guide/Troubleshooting” (separatevolume) thoroughly, and retain them for future reference.http://www.sony.net/Checking the accessories supplied A “Memory Stick Duo” is notsupplied.The camera has its own internalmemory 58 MB (DSC-W70) or32 MB (DSC-W30/W40/W50),however, purchase of a“Memory Stick Duo” isrecommended for shooting moreimages.“Memory Stick Duo”: you canuse a “Memory Stick Duo”with your camera.“Memory Stick”: you cannotuse a “Memory Stick” withyour camera.Other memory cards cannotbe used.• For details on “Memory StickDuo” t “User’s Guide/Troubleshooting” (page 95)• Battery charger BC-CSG/BC-CSGB (1)• Rechargeable battery packNP-BG1 (1)/Battery case (1)• USB, A/V cable for multi-use terminal (1)(DSC-W50/W70)• USB cable (1) (DSC-W30/W40)• A/V cable (1) (DSC-W30/W40)• Wrist strap (1) (DSC-W30/W50/W70)• Neck strap (1) (DSC-W40)• Soft carrying case (1)(DSC-W40)• CD-ROM (Cyber-shotapplication software) (1)• Operating instructions: “ReadThis First” (this manual) (1)• Operating instructions: “User’sGuide/Troubleshooting” (1)Notes• Charge the battery pack (supplied) before using the camera for the first time.• The LCD screen is manufactured using extremely high-precision technology so over 99.99% of thepixels are operational for effective use. However, there may be some tiny black points and/or brightpoints (white, red, blue or green in color) that constantly appear on the LCD screen. These points arenormal in the manufacturing process and do not affect the recording in any way.• The camera is a precision instrument. Be careful notto bump the lens or the LCD screen, and not to applyforce to it. Attach the strap to prevent the camerafrom damage by being dropped, etc.• Designed for use with compatible Sony batteries.Additional information on this product and answers to frequently asked questions can befound at our Customer Support Website.Hook

/ 2

Related manuals for Sony Cyber-shot DSC-W30