32 Turning on the Power (BVM-F250)Chapter 2 PreparationsTurning on the Power(BVM-F250)Connecting the AC Power Cord1 Plug the AC power cord into the AC IN connector onthe left side panel. Then, attach the AC plug holder(supplied) to the AC power cord.2 Slide the AC plug holder over the cord until it locks.To disconnect the AC power cordPull out the AC plug holder while pressing the lock levers.Turning on the MonitorPress the MAIN POWER switch on the left side panel toturn on the power.When you turn on the monitor for the first time afterpurchasing it, the Select Area screen is displayed. Selectthe area where you intend to use this monitor.For selecting the area, see page 34.The warm-up time is more than 30 minutes, approximately.When the monitor is in standby modeAs the OPERATE lamp lights in red in standby mode,press the MONITOR I/1 switch of the controller.The OPERATE lamp lights in green and the monitor entersoperation mode.AC power cord (supplied)AC plug holder (supplied)Attach the AC plug holder to the AC power cord, and connectthe cord to the AC IN connector so that the cord does not comeloose.
