30 Connections (BVM-F170)Chapter 2 PreparationsConnections (BVM-F170)Note on connecting the cable to the DC 5V OUTconnectorBe sure to plug the male connector of the cable into the DC5V OUT connector of the monitor.Insert the connector so as to fit the shape of the DC 5VOUT connector.Connecting the Controller (BKM-16R)1 Turn off the MAIN POWER switch of the monitorbefore connecting the units.2 Set the NETWORK switches of the monitor and thecontroller to PEER TO PEER.3 Connect the LAN (10/100) connector of the monitorand the LAN (10/100) connector of the controller byusing the SMF-700 or the cable supplied with theBKM-39H, or a 10BASE-T/100BASE-TX straightLAN cable (shielded-type, optional).When an optional LAN cable is connected, use ashielded-type cable to prevent a malfunction due tonoises.4 Connect the DC 5V OUT connector of the monitor andthe DC 5V/12V IN connector of the controller by usingthe SMF-700 or the cable supplied with the BKM-39H.Or connect the output cable of the AC adaptor suppliedwith the controller to the DC 5V/12V IN connector ofthe controller.Plug the maleconnector intothe monitor.NoteController(BKM-16R)LAN (10/100) connector DC 5VOUTconnectorDC 5V/12V INconnectorLAN (10/100)connectorSMF-700, etc.BVM-F170NETWORK switcht Set to PEER TO PEER.NETWORK switchtSet to PEER TO PEER.
