Sony BC-VM10 Operating Instructions Manual

Also see for BC-VM10: Instruction & operation manual Operating instructions User manual

Contents

charging time

To remove the battery packRemove the battery pack by sliding it in the opposite direction to whenyou attached it and lifting it straight out.Charging timeBattery pack NP-FM500H NP-FM50 NP-QM71D NP-QM91DNormalcharging time(Approx.)175 min 130 min 280 min 465 minFor more about the battery life, see the instruction manual of yourˎcamera.The charging time may differ depending on the condition of the batteryˎpack or the ambient temperature.The times shown are for charging an empty battery pack, whichˎhas been run down with a camera, using this unit at an ambienttemperature of 25 °C (77 °F).Charging temperatureThe temperature range for charging is 0 °C to 40 °C (32 °F to 104 °F).For maximum battery efficiency, the recommended temperaturerange when charging is 10 °C to 30 °C (50 °F to 86 °F).To use the battery pack quicklyYou can remove the battery pack from this unit and use it even ifcharging is not completed. However, the charging time affects the timethat the battery pack can be used.NotesIf the CHARGE lamp does not light up, check if the battery pack isˎfirmly attached to this unit.When a fully charged battery pack is installed, the CHARGE lampˎlights up once and then goes out.A battery pack that has not been used for a long time may take longerˎthan usual to charge.You can use the battery charger in any country/region where thepower supply is from 100 V to 240 V AC, 50 Hz/60 Hz.Do not use an electronic voltage transformer, as this may cause amalfunction.TroubleshootingWhen the CHARGE lamp blinks, check through the following chart.The CHARGE lamp blinks in two ways.Blinks slowly: Turns on and off repeatedly every 1.5 secondsBlinks quickly: Turns on and off repeatedly every 0.15 secondsThe action to be taken depends on the way the CHARGE lamp blinks.When the CHARGE lamp keeps blinking slowlyCharging is pausing. This unit is in the standby state.If the room temperature is out of the appropriate temperature range,charging stops automatically.When the room temperature returns to the appropriate range, theCHARGE lamp lights up and charging restarts.We recommend charging the battery pack at 10 °C to 30 °C (50 °F to86 °F).When the CHARGE lamp keeps blinking quicklyWhen charging the battery pack for the first time in one of thefollowing situations, the CHARGE lamp may blink quickly.If this happens, remove the battery pack from this unit, reattach it andcharge it again. When the battery pack is left for a long time When the battery pack is left installed in the camera for a long time Immediately after purchaseIf the CHARGE lamp keeps blinking quickly, check through the followingchart.Please contact your nearest Sony dealer in connection with the product that mayhave a problem.Remove the battery pack that is being charged and then firmly attach the samebattery pack again.The CHARGE lamp blinks again:Install another battery pack.The CHARGE lamp lights up anddoes not blink again:If the CHARGE lamp goes outbecause the charging time haspassed, there is no problem.The CHARGE lamp blinks again:The problem is with this unit.The CHARGE lamp lights up anddoes not blink again:If the CHARGE lamp goes outbecause the charging time haspassed, the problem is with thebattery pack first installed.SpecificationsInput rating 100 V - 240 V AC 50 Hz/60 Hz14 VA - 20 VA 9 WOutput rating Battery charge terminal:8.4 V DC 750 mAOperating temperature 0 °C to 40 °C (32 °F to 104 °F)Storage temperature –20 °C to +60 °C (–4 °F to +140 °F)Dimensions (Approx.) 70 mm × 25 mm × 95 mm (w/h/d)(2 7/8 in. × 1 in. × 3 3/4 in.)Mass Approx. 90 g (3.2 oz)Included items Battery Charger (BC-VM10A) (1)Set of printed documentationDesign and specifications are subject to change without notice.Thank you for purchasing the Sony Battery charger.Before operating this Battery charger, please read this manual thoroughlyand retain it for future reference.Owner’s RecordThe model and serial numbers are located on the bottom. Record theserial number in the space provided below. Refer to these numberswhenever you call upon your Sony dealer regarding this product.Model No. BC-VM10 Serial No.WARNINGTo reduce fire or shock hazard, do not expose the unit to rain or moisture.Do not expose the batteries to excessive heat such as sunshine, fire or thelike.To reduce the risk of fire or electric shock,1) do not expose the unit to rain or moisture.2) do not place objects filled with liquids, such as vases, on the apparatus.IMPORTANT SAFETYINSTRUCTIONS-SAVE THESE INSTRUCTIONSDANGERTO REDUCE THE RISK OF FIRE ORELECTRIC SHOCK, CAREFULLYFOLLOW THESE INSTRUCTIONSIf the shape of the plug does not fit the power outlet, use an attachmentˋplug adaptor of the proper configuration for the power outlet.This power unit is intended to be correctly orientated in a vertical orˋfloor mount position.The nameplate indicating operating voltage, power consumption, etc. islocated on the bottom.Battery to be recharged for this product is followsBrand Name SonyBattery Type NP-FM500H NP-FM50 NP-QM71D NP-QM91DRating(Typical Capacity) DC 7.2 V11.8 Wh(1,650 mAh)DC 7.2 V8.5 Wh(1,180 mAh)DC 7.2 V19.9 Wh(2,760 mAh)DC 7.2 V29.8 Wh(4,140 mAh)CAUTIONUse the nearby wall outlet (wall socket) when using this unit.ˎEven when the CHARGE lamp of this unit is off, the power is notdisconnected. If any trouble occurs while this unit is in use, unplug itfrom the wall outlet (wall socket) to disconnect the power.Do not use this unit in a narrow space such as between a wall andˎfurniture.PRECAUTIONThe set is not disconnected from the AC power source (mains) as longas it is connected to the wall outlet (wall socket), even if the set itself hasbeen turned off.NOTICE FOR THE CUSTOMERS IN THE U.S.A.CAUTIONYou are cautioned that any changes or modifications not expresslyapproved in this manual could void your authority to operate thisequipment.NOTEThis equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to Part 15 of the FCC Rules. These limitsare designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, uses,and can radiate radio frequency energy and, if not installed and usedin accordance with the instructions, may cause harmful interference toradio communications.However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined by turningthe equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:Reorient or relocate the receiving antenna.ˋIncrease the separation between the equipment and receiver.ˋConnect the equipment into an outlet on a circuit different from that toˋwhich the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.ˋNotes on UseThis unit does not have dust-proof, splash-proof or water-proofspecifications.Warranty for Recorded ContentContents of the recording cannot be compensated if recording orplayback is not made due to a malfunction of the battery pack, batterycharger, etc.Where not to place this unitDo not place this unit in any of the following locations, whether it is inuse or in storage. Doing so may lead to a malfunction.In direct sunlight such as on dashboards or near heating apparatus, asˎthis unit may become deformed or malfunctionWhere there is excessive vibrationˎWhere there is strong electromagnetism or radiant raysˎWhere there is excessive sandˎIn locations such as the seashore and other sandy areas or where dustclouds occur, protect this unit from sand and dust. There is a risk ofmalfunction.Precautions on UseAttach the battery pack firmly to this unit when charging the batteryˎpack.The battery terminal may be damaged if the battery pack is notˎattached correctly.To protect the battery pack, remove it from this unit when charging isˎcompleted.Do not drop or apply mechanical shock to this unit.ˎKeep this unit away from TVs or AM receivers.ˎNoise from this unit may enter a TV or radio if placed nearby.Unplug this unit from the wall outlet (wall socket) after use. Hold thisˎunit when you unplug it from the wall outlet (wall socket).Be sure that nothing metallic comes into contact with the metal parts ofˎthis unit. If it does, a short may occur and this unit may be damaged.The battery pack and this unit can become warm during orˎimmediately after recharging.MaintenanceIf this unit gets dirty, wipe it using a soft dry cloth.ˎIf this unit gets very dirty, wipe it using a cloth with a little neutralˎsolvent added, and then wipe it dry.Do not use thinners, benzine, alcohol, etc., as they will damage theˎsurface of this unit.When you use a chemical cleaning cloth, refer to its instructionˎmanual.Using a volatile solvent such as an insecticide or keeping this unitˎin contact with a rubber or vinyl product for a long time may causedeterioration or damage to this unit.To Charge the Battery Pack1 Attach the battery pack.Keeping the battery mark  in the same direction as the charger mark, insert the battery pack until it clicks into place. (See illustration).2 Pull the power plug up, and then connect it to a wall outlet(wall socket).Always connect the power plug with the prongs at the top (Seeillustration ).Do not connect the power plug with the prongs at the bottom (Seeillustration ).The CHARGE lamp (orange) lights up and charging begins.When the CHARGE lamp goes out, normal charging is completed(Normal charge).For a full charge, which allows you to use the battery pack longer thanusual, leave the battery pack in place for approximately another onehour (Full charge). The BC-VM10 battery charger can only be used to charge anˎ“InfoLITHIUM” battery pack (M series).“InfoLITHIUM” battery packs (M series) have theˎ mark.This unit cannot be used to charge a nickel cadmium type or nickelˎmetal hydride type battery pack.“InfoLITHIUM” is a trademark of Sony Corporation.ˎBattery  markBattery packPower plugCHARGE lampCharger  markBC-VM104-289-308-11(1)Battery ChargerChargeur de BatterieOperating InstructionsMode d’emploi© 2011 Sony Corporation Printed in China

/ 2

Related manuals for Sony BC-VM10