144There is no picture or picture noiseappears when connected to the DV INjack., Try the following: 1Turn the recorder offand on again. 2Turn the connectedequipment off and on again. 3Disconnectand then connect the i.LINK cable again.There is no picture or picture noise appearswhen connected to the HDMI OUT jack., Try the following: 1Turn the recorder offand on again. 2Turn the connectedequipment off and on again. 3Disconnectand then connect the HDMI cord again., If the HDMI OUT jack is used for videooutput, changing the “Screen Resolution”setting in the “HDMI Output” setup maysolve the problem (page 139). Connect theTV and the recorder using a video jackother than HDMI OUT, and switch theTV’s input to the connected video input sothat you can see the on-screen displays.Change the “Screen Resolution” setting inthe “HDMI Output” setup, and switch theTV’s input back to HDMI. If the picturestill does not appear, repeat the steps andtry other options., The recorder is connected to an inputdevice that is not HDCP compliant(page 22)., When picture noise appears after youchange the “Screen Resolution” setting,hold down x (stop) on the recorder, andpress Z (open/close) on the recorder.TV programme reception does not fill thescreen., Set the channel manually in “Manual CHSetting” in the “Analog Tuner” setup(page 128)., Select the correct source using the INPUTbutton, or select a channel of any TVprogramme using the PROG +/– buttons.The picture is breaking up., The signal strength is low., Check aerial installation.TV programme pictures are distorted., Reorient the TV aerial., Adjust the picture (refer to the TV’sinstruction manual)., Place the recorder and TV farther apart., Place the TV and any bunched aerialcables farther apart., The aerial cable is connected to theAERIAL OUT jack on the recorder.Connect the cable to the AERIAL IN jack., The recorder’s colour system is differentfrom your TV. Hold down x (stop) on therecorder, and press INPUT on the recorderto change the recorder’s colour system.TV channels cannot be changed., A timer recording started, which changedthe channels., The channel is skipped (page 128)., The Parental Lock is activated (page 138).The picture from equipment connected tothe recorder’s input jack does not appearon the screen., If the equipment is connected to the LINE1/DECODER jack, select “L1” in the frontpanel display by pressing INPUT.If the equipment is connected to the LINE2 IN jacks, select “L2” in the front paneldisplay by pressing INPUT.The playback picture or TV programmefrom the equipment connected throughthe recorder is distorted., If the playback picture output from a DVDplayer, VCR, or tuner goes through yourrecorder before reaching your TV, thecopy-protection signal applied to someprogrammes could affect picture quality.Disconnect the playback equipment inquestion and connect it directly to yourTV.The picture does not fill the screen., Set “TV Type” in the “Playback” setup inaccordance with the screen size of your TV(page 137).The picture does not fill the screen, eventhough the picture size is set in “TVType” in the “Playback” setup., The picture size of the title is fixed.
