Siemens SINUMERIK 840D sl Programming Manual

Also see for SINUMERIK 840D sl: Manual Function manual Function manual Function manual Function manual

Contents

No.Screenform param‐eterCycle pa‐rameterMeaning4 S_SETV Diameter of the calibration ball5 alpha 0 S_STA1 Starting angle for measurement at an angle6 alpha 0 S_SETV0 Position value of rotary axis 1 (if rotary axis is manual or semi-automatic)7 alpha 1 S_SETV1 Position value of rotary axis 2 (if rotary axis is manual or semi-automatic) 6)8 XN S_SETV2 Position value for normalizing rotary axis 19 XN S_SETV3 Position value for normalizing of rotary axis 2 6)10 Delta S_SETV4 Tolerance value of the offset vectors I1 to I411 Delta S_SETV5 Tolerance value of rotary axis vectors V1 and V212 TVL S_TNVL Limit value of angular segment of the rotary axis (value range 1 to 60 degrees)(default=20) 7)13 DFA S_FA Measurement path14 TSA S_TSA Safe area15 Measure‐mentsS_NMSP Number of measurements at the same location 2) (default=1)16 S_MCBIT Reserved17 _DMODE Display modeVal‐ues:UNITS: Machining plane G17/G18/G190 = Compatibility, the plane active before the cycle call remains active1 = G17 (only active in the cycle)2 = G18 (only active in the cycle)3 = G19 (only active in the cycle)18 _AMODE Alternative modeVal‐ues:UNITS: Tolerance check yes/no0 = No1 = Yes: Evaluation of the tolerance values of the vectors S_SETV4, S_SETV5TENS: Acknowledgment by the operator when entering the calculated vectors inthe swivel data set 4)0 = yes: Operator must acknowledge the change1 = no: calculated vectors are entered immediately (only effective if HUNDREDSand THOUSANDS position = 0)HUNDREDS: Measurement result display 5)0 = No1 = YesTHOUSANDS: Measurement result display can be edited0 = No1 = Yes, and can be edited (only effective, if the HUNDREDS position = 1)1) All default values = 0 or marked as default=x2) Display depends on the general SD54760 $SNS_MEA_FUNCTION_MASK_PIECE.3) Using this version, for example, for 90 degree positions, the kinematics can be measured at the calibration ball, withoutcolliding with the retaining shaft of the calibration ball. A starting angle S_STA1 (0 to 360 degrees) can be entered. Theincremental angle when circling the ball is equal to 90 degrees.As feedrate along the circular path, the channel-specific SD55634 $SCS_MEA_FEED_PLANE_VALUE is used4) There is an operator prompt with M0 before entering. The vectors are only entered with NC start.If the measuring program is aborted with RESET no calculated vectors are entered.Vectors are only entered when the tolerance of the offset vectors has not been exceeded during the calculation.Work preparation3.25 Programming cycles externallyNC programming1186 Programming Manual, 12/2019, 6FC5398-2EP40-0BA0