Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

Column heading MeaningTool name The tool is identified by the name and the sister tool number. You may enterthe names as text or numbers.Note: The maximum length of tool names is 31 ASCII characters. The num‐ber of characters is reduced for Asian characters or Unicode characters.The following special characters are not permitted: | # ".ST Sister tool number (for sister tool strategy)D Cutting edge numberLength X, length Y, lengthZTool lengthGeometry length length X, length Y, length ZRadius Tool radius∅ Tool diameterWidth/Tip width/Tip angle /PitchDrilling radiusCutting edge for Type 150 - side milling cutter and Type 151 - sawTip width for Type 520 - plunge cutter and Type 530 - cut-off toolTip angle for Type 200 – twist drill and Type 220 – centering tool and Type230 – countersinkPitch for Type 240 - tapDrilling radius for Type 560 - rotary drill. Holder angle and cutting tip angleare fixed.Cutting edge graphicThe cutting edge graphic shows the positioning defined by the holder angle,cut direction and cutting tip angle.Holder angle for Type 500 - rougher and Type 510 - finisher.The reference direction for the holder angle specifies the cut direction.In addition to the holder angle, the cutting tip angle is also specified.N Number of teeth for Type 100 - milling tool, Type 110 - ball end mill forcylindrical die-sinking cutter, Type 111 - ball end mill or tapered die-sinkingcutter, Type 120 - end mill, Type 121 - end mill with corner rounding, Type130 - angle head cutter, Type 131 - angle head cutter with corner rounding,Type 140 - facing tool, Type 150 - side mill, Type 155 - bevel cutter, Type156 - bevel cutter with corner rounding and Type 157 - tapered die-sinkingcutter.Tip length Tip length of a cutting tool or grooving cutterThe tip length is required for displaying the tools during the simulation ofthe program processing.Direction of spindle rotationSpindle is not switched onCW spindle rotationCCW spindle rotationCoolant 1 and 2 (e.g. internal and external cooling) can be switched on andoff.The coolant infeed at the machine does not necessarily have to be set-up.M1 - M4 Other tool-specific functions such as additional coolant infeed, monitoringfunctions for speed, tool breakage, etc.Tool management13.5 Tool listMilling638 Operating Manual, 05/2017, A5E40868956