Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

NoteFurther details on zero offsetsIf you would like to see further details about the specified offsets or if you would like to changevalues for the rotation, scaling or mirroring, press the "Details" softkey.4.8.2 Displaying the zero offset "overview"The active offsets or system offsets are displayed for all axes that have been the setup in the"Work offset - overview" window.In addition to the offset (course and fine), the associated rotation, scaling and mirroring arealso displayed.This window is generally used only for monitoring.Display of active work offsetsWork offsetsMCS actual value Display of the actual value in the Machine Coordinate Sys‐tem.Kin. trans. workpiece Displays the additional work offsets programmed with$P_TRAFRAME_P.Kin. trans. tool Displays the additional work offsets programmed with$P_TRAFRAME_T.DRF Displays the handwheel axis offset.$AA_OFF overlay Displays the overlaid movement programmed with$AA_OFF.Basic reference Displays the additional work offsets programmed with$P_SETFRAME.Access to the system offsets is protected via a keyswitch.External WO frame Displays the additional work offsets programmed with$P_EXTFRAME.Total base WO Displays all effective basis offsets.G500 Displays the work offsets activated with G54 - G599.Under certain circumstances, you can change the data us‐ing "Set WO", i.e. you can correct a zero point that has beenset.Tool reference Displays the additional work offsets programmed with$P_TOOLFRAME.Workpiece reference Displays the additional work offsets programmed with$P_WPFRAME.Transformer reference Displays the additional work offsets programmed with$P_TRAFRAME.Setting up the machine4.8 Zero offsetsMillingOperating Manual, 05/2017, A5E40868956 121