Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

6. Press the ">>" and "View" softkeys.7. Press the "Open blocks" softkey if you wish to display the program withall blocks.8. Press the "Close blocks" softkey if you wish to display the program againin a structured form.Remove block9. Open the block.10. Position the cursor at the end of the block.11. Press the "Remove block" softkey.NoteYou can also open and close blocks using the mouse or with the cursor keys:● opens the block at the location where the cursor is● closes the block if the cursor is located at the beginning or end of the block● and closes the block if the cursor is located within the blockNoteDEF statements in program blocks or block generation in the DEF part of a part program /cycle are not permitted.6.10.6 Opening additional programsYou have the option of viewing and editing several programs simultaneously in the editor.For instance, you can copy program blocks or machining steps of a program and paste theminto another program.Opening several programsYou have the option of opening up to ten program blocks.1. In the program manager, select the programs that you wish to open andview in the multiple editor and then press on the "Open" softkey.The editor is opened and the first two programs are displayed.2. Press the key to change to the next opened program.3. Press the "Close" softkey to close the actual program.Machining the workpiece6.10 Editing a programMilling184 Operating Manual, 05/2017, A5E40868956