Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Service manual

Contents

Programming technology functions (cycles)8.1 DrillingTurning288 Operating Manual, 02/2012, 6FC5398-8CP40-3BA0Parameter Description UnitMachiningposition (onlyfor G code) Single positionDrill hole at programmed position Position patternPosition with MCALLZ0 (only for Gcode)Reference point Z mmMachiningsurface(only forShopTurn) Face C Face Y Peripheral surface C Peripheral surface YPosition(only forShopTurn) At the front (face) At the rear (face) Outside (peripheral surface) Inside (peripheral surface)(only forShopTurn)Clamp/release spindleThe function must be set up by the machine manufacturer.Centering  Diameter (centered with reference to the diameter)The angle for the center drill entered in the tool list is applied. Tip (centered with reference to the depth)The drill is inserted into the workpiece until the programmed insertion depth is reached.∅ It is inserted into the workpiece until the diameter is correct. - (for diameter centeringonly)mmZ1 Drilling depth (abs) or drilling depth in relation to Z0 (inc)It is inserted into the workpiece until it reaches Z1. - (for tip centering only)mmDT  Dwell time (at final drilling depth) in seconds Dwell time (at final drilling depth) in revolutionssrev