Siemens SINUMERIK 840D Operator's Manual

Also see for SINUMERIK 810D: Programming manual Programming manual Programming manual Function manual Function manual

Contents

6 03.04 "Program" Operating Area6.10 Manage programs 6 Siemens AG, 2004. All rights reservedSINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition 6-349Abort This key cancels the entire operation.OK Press the "OK" softkey to load the workpiece or part program youhave just selected. You can then use the program managementfunctions available in the horizontal softkey menu.6.10.8 Copy/pasteFunctionThis section tells you how to copy files from a source directory to anexisting destination directory.Except when overwriting workpieces, the files are copied from the NCprogram memory or from the hard disk to:Hard disk (HD) orNC memory (NCK) orIntermediate memory orDiskette (is specified as network drive) orNetwork drive (Network1 to Network4 with SW 6.3 and higher)All directories with the exception of compile cycles can be copied tothe destinations specified above.Copy/paste, SW 6.3 and higherSeveral selected files or workpieces can be copied together in asingle operation.When copying workpieces:All associated files are copied too.All files with the workpiece name are automaticrenamed to the new workpiece name.Files from the Workpieces directory can only be overwrittenin another directory.All workpiece files of type .WPD can be copied fromone drive to any drive.