4 03.04 Machine Operating Area4.6 Automatic mode 4 Siemens AG, 2004. All rights reservedSINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition 4-157BlocksearchSwitch to the "Search position" dialog.Define search destination in program editor:SearchpositionThe current selected program level is displayed.Position the cursor bar on a destination block of your choice in thepart program.Programlevel + orProgramlevel -You can toggle between program levels using these softkeys ifnecessary.Prog. testcontourStart of search in Program test mode.A dialog message appears as soon as all the channels involved in thecurrent search have exited program test mode. This messageindicates that Repos offsets may, depending on the particular partprogram, have been produced in the channels involved during theblock search and will be retracted by the NC through interpolation thenext time it starts. You must acknowledge this message.The repositioning offsets that occur may be traversed manually inJOG mode before continuing program processing with the "NC Start"key at the program position reached in the block search.Defining the search destination in the search pointer:SearchpointerOnce the softkey "search pointer" has been pressed, a screen withthe program pointer is displayed.It contains input fields for program name, search type (block number,text, ...) and search destination (content). The cursor is positioned inthe input field for the "search type".Prog. testcontourStart of search in Program test mode.A dialog message appears as soon as all the channels involved in thecurrent search have exited program test mode (see above). "Searchtarget in the program editor".Any repositioning offsets (in the individual channels) can be retractedin sequence via manually controlled traversing movements in JOGmode, before program processing is continued via NC Start at thepoint in the program reached by the block search.
