4 Machine Operating Area 03.044.4 Jog operating mode 4 Siemens AG, 2004. All rights reserved4-88 SINUMERIK 840D/810D Operator’s Guide HMI Embedded (BEM) – 03.04 EditionExplanation of the Jogbasic displayMotion symbol in actual value window: The axes are still moving, i.e.they are not within the exact stop window.WCS+ X2*Y2*Z2*Displays the addresses of the existing axes with the machine axisidentifier (MCS) or with the geometric axis identifier (WCS).(see also Section "Toggling between Machine/Workpiece CoordinateSystem (MCS/WCS)")Machine manufacturer Machine data are used to define whether the programmed frames areto be calculated when displaying the WCS (settable zero system =SZS display). Please refer to the information and specificationsprovided by the machine manufacturer.• If the axis identifier can only be displayed in an abbreviated form itis replaced by the character *.• If you traverse an axis in the positive (+) or negative (-) direction, aplus or minus sign is shown in the relevant field.The axis is in position if neither + nor – is displayed in the positiondisplay.Position0.00.1–0.11.10.0The actual position of each configured axis in the machine (MCS) orwork (WCS) is displayed in these fields.The sign is only displayed for negative values.Repos. offset0.00.1–0.11.10.0If the axes are traversed in the "Program interrupted" status in "Jog"mode, the path traversed by every axis with respect to the point ofinterruption is displayed in the REPOS offset.SpindlerpmSpindle window (if spindle is available)Displays the set and actual value of the spindle speed, the position ofthe spindle, the position of the spindle override switch , andthe spindle power.
