Siemens SIMATIC V2 Operating Instructions Manual

Also see for SIMATIC IFP V2: Operating instructions Quick install guide

Technical information7.1 Certificates and approvalsIFP V2, IFP V2 PRO, IFP V2 ETHOperating Instructions, 03/2023, A5E46641410-AE 89non-conductive dust environment and IP6X in accordance with GB 12476.1 & GB 12476.5for Zone 22 conductive dust environment.During use, make allowances for the ambient conditions.• The equipment shall be installed in such a way that the risk of mechanical danger is low.• To avoid an electrostatic charge, wipe the enclosure surface with a damp cloth only.• When used in an area requiring the use of equipment with EPL Gc, the followingadditional conditions apply:– The equipment shall only be used in an area of not more than pollution degree 2, asdefined in GB/T 16935.1.– Provisions shall be made to prevent the rated voltage from being exceeded by transientdisturbances of more than 119 V.FCC and CanadaUSAFederal CommunicationsCommissionRadio Frequency Interfer-ence StatementThis equipment has been tested and found to comply with the limits for aClass A digital device, pursuant to Part 15 of the FCC Rules. These limitsare designed to provide reasonable protection against harmful interfer-ence when the equipment is operated in a commercial environment. Thisequipment generates, uses, and can radiate radio frequency energy and, ifnot installed and used in accordance with the instruction manual, maycause harmful interference to radio communications. Operation of thisequipment in a residential area is likely to cause harmful interference inwhich case the user will be required to correct the interference at his ownexpense.Shielded Cables Shielded cables must be used with this equipment to maintain compliancewith FCC regulations.Modifications Changes or modifications not expressly approved by the manufacturercould void the user's authority to operate the equipment.Conditions of Operations This device complies with Part 15 of the FCC Rules. Operation is subject tothe following two conditions: (1) this device may not cause harmful inter-ference, and (2) this device must accept any interference received, includ-ing interference that may cause undesired operation.CANADACanadian Notice This Class A digital apparatus complies with Canadian ICES-003 (A).Avis Canadien Cet appareil numérique de la classe A est conforme à la norme NMB-003 (A) du Canada.Responsible party for Supplier's Declaration of Conformity in the USASiemens Industry, Inc.Digital Factory - Factory Automation5300 Triangle Parkway, Suite 100Norcross, GA 30092USAMail to: (amps.automation@siemens.com)