88-3ET 200 Distributed I/O SystemEWA 4NEB 780 6000-02aYou create a new program file when you1. Start COM ET 200 Windows and2. in COM ET 200 Windows, select File New.3. Enter the parameters in the Master host selection dialog box and4. press ”OK” to confirm.Result: A new program file is created with the designation ”noname.et2”.In addition, a window bearing the title ”Master system: station number X” isopened and you can start parameterization of a master system.There are two ways of opening an existing program file: Click on the icon for File Openor using File Open, select an existing program file.If you want to import data from a memory card, your programmer must have a memory card interface, or your programmer must have an E(E)PROM slot with the appropriateprogramming adapter, or your PC must have an external programming unit.Remember, too, that the memory card drivers have to be loaded beforehand,i.e. when MS-WINDOWS starts.The order numbers are listed in Appendix F.If you want to load data from a memory card, the memory card must beconnected to the memory card interface of the programmer.To load the data, select File Import Memory card.Result: The data of a master system is available in the program file openedby these commands.NoteYou cannot reconstruct the entire bus system and store the configuration in asingle program file until you have imported the data from all the memorycards, each of which contains the data for a single master system. This datain its entirety constitutes the map of the bus-system configuration.Creating a fileOpening aprogram fileSystemrequirements formemory cardsImporting datafrom memory cardParameterizing, saving and documenting the configuration with COM ET 200 Windows
