Siemens CB634GB 3 Series User Manual And Installation Instructions

Also see for CB634GB 3 Series: User manual and installation instructions

en Installation instructions30¡ The power cable must be plugged in at the rear ofthe appliance until you hear a clicking sound. A 3 mpower cable can be obtained from the after-salesservice.¡ The power cable must only be replaced with a cablefrom the original manufacturer. This is available fromafter-sales service.¡ Contact protection must be guaranteed by the in-stallation.Electrically connect the appliance with theprotective contact plugNote: The appliance must only be connected to a pro-tective contact socket that has been correctly installed.▶ Insert the plug into the protective contact socket.When the appliance is installed, the mains plug ofthe power cord must be freely accessible. If free ac-cess to the mains plug is impossible, an all-poleisolating switch must be integrated into the perman-ent electrical installation in accordance with the in-stallation regulations.Electrically connecting an appliance without aprotective contact plugNote: Only a licensed professional may connect the ap-pliance. Damage caused by incorrect connection is notcovered under the warranty.An all-pole isolating switch must be integrated into thepermanent electrical installation according to the install-ation regulations.1. Identify the phase and neutral conductors in thesocket.The appliance may be damaged if it is not connec-ted correctly.2. Connect the hob in accordance with the connectiondiagram.See the rating plate for the voltage.3. Connect the wires of the mains power cable accord-ing to the colour coding:‒ Green/yellow = Protective conductor‒ Blue = Neutral conductor‒ Brown = Phase (external conductor)22.9 Installing the appliance1. Slide the appliance in fully and centre it.2. Screw the appliance into place.3. For handleless kitchens with vertical bar handlestrips:‒ Attach a suitable filling piece in order to coverany sharp edges and to guarantee a safe install-ation.‒ Pre-drill aluminium profiles to establish a screwconnection .‒ Secure the appliance using a suitable screw .Note: The gap between the worktop and the appliancemust not be closed by additional battens.Thermal insulation strips must not be fitted to the sidepanels of the surround unit.22.10 Removing the appliance1. Disconnect the appliance from the power supply.2. Undo the fastening screws.3. Lift the appliance slightly and pull it out completely.

/ 32

Related manuals for Siemens CB634GB 3 Series