Siemens CB634GB 3 Series User Manual And Installation Instructions

Also see for CB634GB 3 Series: User manual and installation instructions

Installation instructions en27Recommended settings for bakingFood Accessory/cookware Shelf pos-itionHeatingfunction→ Page 7Temperature in°CCooking time inminsViennese whirls Baking tray 1 150 - 160 1 25 - 40Viennese whirls Baking tray 1 140 - 150 1 25 - 40Viennese whirls, on 2 levels Universal pan+Baking tray3+1 140 - 150 1 30 - 40Small cakes Baking tray 1 160 1 25 - 35Small cakes Baking tray 1 150 1 25 - 35Small cakes, on 2 levels Universal pan+Baking tray3+1 150 1 25 - 35Hot water sponge cake Springform cake tin,diameter 26 cm1 160 - 170 2 25 - 35Hot water sponge cake Springform cake tin,diameter 26 cm1 160 - 170 2 25 - 351 Preheat the appliance for five minutes. Do not use the rapid heating function.2 Preheat the appliance. Do not use the rapid heating function.Recommended settings for grillingFood Accessory/cookware Shelf pos-itionHeatingfunction→ Page 7Temperature in°C/grill settingCooking time inminsToasting bread Wire rack 3 3 3 - 622 Installation instructionsObserve this information when installing the appliance.22.1 General installation instructionsFollow these instructions before you start withthe installation of the appliance.¡ The safe operation of this appliance canonly be guaranteed if it has been installedto a professional standard in accordancewith these installation instructions. The in-staller shall be liable for damages incurredas a result of incorrect installation.¡ Check the appliance for damage after un-packing it. Do not connect the appliance ifit has been damaged in transit.¡ Before starting up the appliance, removeany packaging material and adhesive filmfrom the cooking compartment and thedoor.¡ Proceed in accordance with the installationsheets for installing accessories.¡ Fitted units must be heat-resistant up to95 °C, and adjacent unit fronts up to70 °C.¡ Do not install the appliance behind a decor-ative door or the door of a kitchen unit.There is a risk of overheating.¡ Cut-out work on the units should be carriedout before installing the appliance. Removeany shavings. Otherwise, the correct opera-tion of electrical components may be ad-versely affected.¡ The mains socket for the appliance musteither be located in the hatched area oroutside of the area where the appliance isinstalled.Any unsecured units must be secured tothe wall using a standard bracket .