Siemens BE555LM 0 Series User Manual And Installation Instructions

Also see for BE555LM 0 Series: User manual and installation instructions

Basic settings en13Programme Food Cookware Weight range in kgP08 Frozen bake, up to 3 cm deep Open 0.40–0.90Cooking food using the combi cookingprogramme1. Take the food out of its packaging.2. Weigh the food.You require the weight in order to set the pro-gramme.3. Place the food in microwave-safe, heat-resistantcookware that is not too big.4. Set the programme. → Page 115. Once the programme has finished, leave the food torest for another 5–10 minutes to allow the temperat-ure to even out.Basic settings11 Basic settingsBasic settingsYou can configure the basic settings for your appliance to meet your needs.11.1 Overview of the basic settingsHere you can find an overview of the basic settings and factory settings. The basic settings depend on the featuresof your appliance.Setting Selection MeaningButton tone ¡ 1¡Switch the button tone on and off.Note: The button tone remains active for and .Demo mode Activate or deactivate demo mode.Note: The appliance is switched off. You can use the buttons and the display; the but-tons do not work. Demo mode is mainly useful for dealers.1 Factory setting (may vary according to model)11.2 Changing basic settingsRequirement: The appliance is switched off.1. Press and hold and for a few seconds.a The display shows the first basic setting.2. Press .a The current value flashes on the display.3. Use the settings area to set the required value.4. To accept the basic setting, press .5. To exit the basic setting, press .6. Use the settings area to switch to the basic setting.7. To edit the basic setting, press .a The selected setting lights up on the display.8. Use the settings area to set the required value.9. To accept the basic setting, press .10. To exit the basic setting, press .11. To exit the basic settings menu, press again.Tip: The setting can be changed at any time.11.3 Changing the signal durationWhen your appliance is switched off, you hear an aud-ible signal. You can change the duration of the signal.▶ Press and hold for approx. six seconds.a The signal duration switches between short andlong.a The appliance applies the signal duration and dis-plays the time.11.4 Setting the timeNote: After connecting the appliance to the power orfollowing a power cut, a signal sounds and severalzeros are shown on the display. It may take a fewseconds until a signal sounds and you can set thetime.Requirements¡ An audible signal sounds.¡ 12:00 is shown on the display.¡ The indicator light lights up via .1. Set the time via the settings area.2. Press .11.5 Hiding the clockTo reduce the standby consumption of your appliance,you can hide the clock.1. Press .2. Press .To view the clock, press again.