Sharp PN-70TA3 Operation Manual

Also see for PN-60TA3: Operation manual Operation manual Operation manual Operation manual Operation manual

Contents

52EControlling the Monitor with a PC (LAN)■ SNMPYou can configure settings related to SNMP.SNMP SETTINGSet whether to enable or disable SNMP.VERSIONSet the version of the SNMP to be supported.COMMUNITY NAME 1 to 3Set the name of the community required for the access.USER 1 to 3Set the user name, password, authentication method andother options required for access.TRAP SETTINGSet whether to enable or disable the trap function.When this function is enabled, a trap will be sent when themonitor is turned on.A test transmission of a trap can be performed in “Test”.TRAP SETTING OF AUTHENTICATION ERRORSet whether the trap function sends a notification whenauthentication fails.TRAP ADDRESS & PORTSet the destination address and port number of thenotification sent by the trap function.Caution• After you set SNMP, click [Switch the main power of monitoroff and on now.] or turn off the monitor and then turn it onagain with the main power switch. Before switching off themain power switch, always put the monitor in the Power off(Standby mode) state.When the monitor restarts, wait about 30 seconds and thenstart the next operation.• If the IP address is changed while the SNMP function isoperational, turn off the monitor and then turn it on againwith the main power switch. Before switching off the mainpower switch, always put the monitor in the Power off(Standby mode) state.TIPS• Depending on the SNMP settings, a short delay may occurbefore the SNMP is usable. (About 5 minutes)• Up to 16 alphanumeric letters and symbols can be used forthe community name, user name and password.■ SERVICE & SUPPORT(URL INFORMATION)You can display a specific URL in the URL INFORMATIONfield on the INFORMATION screen when an error occurs inthe monitor. (See page 48.)URL INFORMATIONEnter the URL to display on the INFORMATION screen whenan error occurs on the monitor.Up to 64 alphanumeric characters or symbols can be used.CONDITIONSpecify the condition to display the URL.CONFIRMATIONThe home page of the specified URL is displayed.You can check whether the URL you entered is correct.TIPS• It is also possible to specify the message text, such as thename of a contact or a telephone number, to be displayedinstead of the linked URL.