Sharp PN-70TA3 Operation Manual

Also see for PN-60TA3: Operation manual Operation manual Operation manual Operation manual Operation manual

Contents

35 EMenu ItemsADVANCEDAUTO (D-SUB1[RGB]/D-SUB2/WHITEBOARD)The ANALOG GAIN and ANALOG OFFSET are automatically adjusted.Pressing ENTERperforms adjustment.ANALOG GAIN (D-SUB1[RGB]/D-SUB2/WHITEBOARD)Adjusts the bright portions of the video input signal.ANALOG OFFSET (D-SUB1[RGB]/D-SUB2/WHITEBOARD)Adjusts the dark portions of the video input signal.3D-NR (AV input)Reduce the noise of playback images on video.Setting a higher level reduces more noise. However, it may cause blurring on an image.MPEG-NR (AV input)Reduce block noise caused by digital compression.3D-Y/C (D-SUB1[VIDEO])Specify whether to perform 3-dimension Y/C separation.If dot interference or cross-color is occurring in fast-motion scenes, selecting “OFF” may improve the image quality.RGB INPUT RANGE (HDMI[PC]/HDMI[AV]/D-SUB1[RGB]/D-SUB2/DisplayPort/WHITEBOARD)Sets the RGB input signal range. When using HDMI or DisplayPort set to AUTO, the RGB input signal range is detectedautomatically. Use AUTO normally.If the RGB input signal range cannot be set appropriately even when using AUTO, set according to the image. When thesetting is different, images will be displayed with washed out blacks and compressed gradients.ACTIVE CONTRAST (AV input)Automatically adjusts the contrast according to the image.(In PIP mode, the main side setting is reflected in the image.)The adjustment operation may not be smooth depending on the image. In this case select OFF.DISPLAY COLOR PATTERNDisplays a color pattern. Can be displayed while the menu screen is displayed, so you can refer to the pattern while adjustingthe image.OFF ...............No pattern display.WHITE...........White single color pattern display.RED...............Red single color pattern display.GREEN .........Green single color pattern display.BLUE .............Blue single color pattern display.USER ............Red/green/blue mixed color pattern display. When USER is selected, set each color’s level.RESETResets the values of the PICTURE menu items to the factory preset values.Select “ON” and then press ENTER.