Sharp PN-70TA3 Operation Manual

Also see for PN-60TA3: Operation manual Operation manual Operation manual Operation manual Operation manual

Contents

38EnMONITOROSD H-POSITIONAdjusts the horizontal display position of menu screen.OSD V-POSITIONAdjusts the vertical display position of menu screen.OPERATION MODEMODE1 ......OFF IF NO OPERATION is set to ON, and STANDBY MODE is set to LOW POWER.(These settings can not be changed.)MODE2 ......Will perform standard operation. OFF IF NO OPERATION is set to OFF, and STANDBY MODE is set toSTANDARD. These settings can be changed.STANDBY MODEWhen STANDARD is selected, startup time from standby mode is reduced. Note, however that, more power will be consumedin standby mode.When LOW POWER is selected, current consumption is reduced while the monitor is in standby mode. Note, however, that thestartup time from standby mode becomes longer.When LOW POWER is set, LAN control is not possible in standby mode.OFF IF NO OPERATIONDetermines whether or not to set the monitor to go into standby mode when there is no operation from the remote control unit,or LAN for over 4 hours.When there is unsaved data on the WHITEBOARD, a data save message will appear about once a minute starting about 5minutes prior to power off. Save data you need. When the power turns off, the data will be lost.POWER ON DELAYIf SET is set to ON, you can delay the screen display after the monitor is turned on. When ON is selected, set the delay timewith INTERVAL (interval can be set up to 60 seconds in units of 1 second).When this function is activated, the power LED flashes (at approx. 0.5 second interval) in green.SELF ADJUSTOn a D-SUB1[RGB]/D-SUB2 screen, specify whether to perform screen adjustment automatically or not.When ON is selected, the screen is automatically adjusted when its resolution is 800 x 600 or higher and the timing of inputsignals changes. “ADJUSTING” appears on the screen during the adjustment.If SELF ADJUST is set to ON, set the time it takes to start the SELF ADJUST function in START TIMING.For images with black edges, etc., depending on the signal, adjustment may not be possible. In this case select OFF. (Performmanual adjustment of the screen.)TOUCH OUTPUT INVALID DISP.TOUCH OUTPUT INVALID ICONSets whether the TOUCH OUTPUT INVALID icon is displayed when touch action is disabled.CHANGE DISPLAY POSITIONSets the display position of the TOUCH OUTPUT INVALID icon.TOUCH OPERATION MODESelect the touch mode.AUTO.............................. Automatically switches between MOUSE MODE and MULTI-TOUCH MODE.MOUSE MODE............... Touch information is output as mouse information.MULTI-TOUCH MODE ... Touch information is output as digitizer information.* If Touch Panel Settings Tool is installed on your computer, set with the Touch Panel Settings Tool.* The touch panel must be connected in order to configure this setting.TOUCH PANEL MODE (PC input)When the resolution is 1920 x 1080, setting this to ON improves touch panel tracking.When two screens are displayed, or when V-POS or V-SIZE is adjusted on the SCREEN menu, the screen may becomedistorted. In this event, set to OFF.Menu Items