Sharp Aquos LC-60LE640X Operation Manual

41Basic adjustmentButtons for “Manual adjust” operationLock Press R button.When the service is locked, you must enter your passwordwhenever you tune to the service.CH skip Press G button.Services with a  mark are passed over when pressingCHr/s on the TV or remote control unit.Delete Press Y button.The selected service is deleted. If you want to watch theservice you deleted once again, perform “Auto installation”,“Additional search”, or “Manual search”.Sort Press B button.The item position of services can be sorted.1 Press a/b to select the service whose item positionyou want to move, and then press ?.2 Press a/b to move it to the desired position, and thenpress ?.3 Repeat steps 1 and 2 until all desired service items aresorted.Analogue setting1 Go to “HOME” > “TV Menu” > “Setup” > “Viewsetting” > “Channel setting” > “Programmesetup”.2 If you have already set the password, enter it here.• See page 43 for setting a password.3 The “Analogue setting” screen displays, and thenpress ?.4 Repeat steps 4 and 5 in Digital setting.NOTE• The “Analogue setting” menu is available only for watching TVin ATV mode.Additional searchUse this menu to add new services automatically after“Analogue Search” in the “Auto installation” menu hasbeen completed.• Start searching channels after selecting the colour systemand sound system.Manual adjustYou can reconfigure the analogue TV channels settingsautomatically or manually.After selecting “Yes” on the screen, press a/b/c/d to select the channel you want to set andthen press ?.Programme Setup “Manual adjust” menuNextYou can select one of the following settings.SearchYou can add a new channel within a specified frequency band.ItemNext Search the next channel.Store Memorise the current display channel.Cancel Return to the previous screen (the searchresult will not be stored).FineYou can adjust the frequency to the desired position.1 You can set by directly entering the frequencynumber of the channel with 0–9 numeric buttons.EXAMPLE• 179.25 MHz: Press 1 > 7 > 9 > 2 > 5.• 49.25 MHz: Press 4 > 9 > 2 > 5 > ?.NOTE• Adjust while checking the background picture as a reference.• When setting a frequency on the “Fine” screen, the last figureof the frequency needs to be “0” or “5”.Colour sys.Select the optimum colour system to receive (“Auto”,“PAL”, “SECAM”, “NTSC3.58”).Sound sys.Select the optimum sound systems (broadcastingsystems) to receive (“B/G”, “D/K”, “I”, “M”).NOTE• Check the sound system if the sound output were notcorrect.