Sharp AN-WC11B Operation Manual

-24Selecting the “Peer-to-Peer Channel”When communicating in “Peer-to-Peer”, you must specify a channel on which communications willtake place.1 Select the channel you want to set from the box on the right of “Peer-to-PeerChannel”.The channels that can be selected are displayed in a list.2 Click “Apply”.The channel is changed to the channel you selected.The “Peer-to-Peer Channel” is displayed in gray in “Access Point”. The Access Point changes thechannel automatically; therefore it is not necessary to set the channel in the “Access Point”. Setting the Transmit RateYou can specify the speed data is sent by the Wireless LAN PC Card.Setting the Transmit Rate1 Click the pull down button on the right of the “Transmit Rate” box.The transmit rates that can be selected are displayed in a list.2 Select the transmit rate you want to set and click “Apply”.The speed is changed to the selected “Transmit Rate”.The transmit rate can be set to:• Fully Automatic – your Wireless LAN PC Card chooses the highest available rate providingreliable communications based on the capabilities of the Access Point orWireless LAN PC Card with communicates and on the received signal quality• Auto 1 or 2 Mb – allows only 1 and 2 Mbps operation• 5.5 Mb – allows only 5.5 Mbps operation• 11 Mb – allows only 11Mbps operationNormary, you should choose “Fully Automatic” as the transmit rate. Change the setting, only when aproblem occurs.