Sharp AL-2020 Service Manual

Also see for AL-2020: Online manual Operation manual Leaflet Service manual

Contents

AL-2020/2035/2040/2050/2060 SIMULATION, TROUBLE CODES 10 - 2850 12 Document off-centeradjustment[Function]Used to adjust document scan off-center adjustment.The adjustment modes can be selected by pressing [Exposure mode selector] key (or [ ][ ] key for the AL-2050/2060). (Adjustment range: 1 – 99, Default: 50)When the adjustment value is increased, the print result is shifted to left.* When paper is discharged, the shifter is operated.[Operation]The operation is similar to simulation 46-01.18 Memory reverse positionadjustment in duplex copy[Function]When this simulation is executed, the current set correction value is displayed.Enter the correction value and press [START] key to save the entered correction value. (Correc-tion value range; 1 – 99, Default: 50)For S-D mode front surface print and print of even paged in D-S mode, reverse memory copyoperation is performed from the rear edge of documents.When, therefore, the print position adjustment of output images is required, adjust as follows:In the reverse memory coping, when the document scan is made in the arrow direction, the out-put image is printed from the rear edge of scan image.When, therefore, the print lead edge is shifted, set the reference chart so that the referenceposition is on the rear edge, and use this simulation to adjust the set value so that the print leadedge is matched.Since printing is made from the image data most lately stored in memory to the lead edge datafrom the print start position, the image lead edge adjustment is made by changing the end dataposition stored in memory by the set value of this simulation.Since it is performed by changing the scan end position, the image position adjustment is madeby changing the scan end position and the end data stored in memory.The adjustment modes can be selected by pressing [Exposure mode selector] key (or [ ][ ] key for the AL-2050/2060)* The initial value of duplex setting is "1to2/Long Edge" for the duplex model, or "2to1" for thesimplex model.∗ When paper is discharged, the shifter is operated.[Operation]The operation is similar to simulation 46-01.MaincodeSubcode Contents Details of function/operationModeInitial valueof duplexsettingDisplay item(AL-2050/2060)LED(AL-2050/2060)Display lamp(AL-2020/2035/2040)DefaultPlaten documentscanS-S OC COPY modelampAE mode lamp 50SPF documentfront scanS-S SPF PRINT modelampTEXT modelamp50RSPF documentback scan(AL-2050/2060)D-S RSPF SCAN modelamp— 50ModeInitial valueof duplexsettingDisplay item(AL-2050/2060)LED(AL-2050/2060)Display lamp(AL-2020/2035/2040)DefaultOC memory reverseoutput positionS-D OC COPY modelampAE mode lamp 50SPF/RSPF memoryreverse output positionD-S SPF PRINT modelampTEXT modelamp50Document transport direction Document transport directionScan lead edge Print lead edgeLead edge void (1)Print start positionScan end position(Default: Scan cut by void (1)) Rear edge voidPrint rear edgeScan direction Scan rear edge