Sharp AL-1020 Service Manual

Also see for AL-1020: Operation manual

Contents

3. AE level adjustment (OC mode)[Input method]When the PHOTO lamp lights up, press and hold the densityselect key for 5 sec, and the AUTO mode lamp will blink andthe adjusted level will be displayed on the exposure level dis-play.[Adjustment]For adjustment, press the density adjustment key too select thedensity in 5 steps.[Terminating method]Press the density select key, and the model display will turnfrom blinking to lighting to terminate the AE level adjustment.4. AE level adjustment (SPF mode)[Input method]While the SPF mode lamp is lighting, when the PHOTO modelamp lights up, press and hold the density select key for 5 sec,and the AUTO mode lamp will blink and the adjusted level willbe displayed on the exposure level display.[Adjustment]For adjustment, press the density adjustment key to select thedensity in 5 steps.[Terminating method]When the density select key is pressed, the mode display willturn from blinking to lighting to terminate the AE level adjust-ment.5. Toner save mode setup and cancel[Input method]When the TEST mode lamp lights up, press and hold the den-sity select key for 5 sec, and the PHOTO mode lamp will turnfrom blinking to lighting and the adjusted level will be displayedon the exposure level display.[Setup/Cancel]Press the left key: Level “1” ON, toner save mode setup Pressthe right key: Level “5” ON, toner save mode cancel.[Terminating method]When the density select key is pressed, the mode display turnsfrom blinking to lighting to terminate setup.AL-12508-2